Manual

36
CHECKING THE ALARM: VIEW THE MOST RECENT ALARM CONDITION
If the alarm should go off, the point which went into alarm most recently may be checked and quieted from
either of the Top-Level menus.
To Check the Alarm in “Setup” Menu:
Sponsler V6.13 MS197
Run?
Sponsler V6.13 MS197
Set Computations?
Sponsler V6.13 MS197
Engineering Units?
Sponsler V6.13 MS197
Set Hardware?
Sponsler V6.13 MS197
Set Variables?
Sponsler V6.13 MS197
Clear Totalizer?
Sponsler V6.13 MS197
Check Alarm?
The most recent alarm condition will be
Alarm Condition displayed on the top line. Pressing will
Press ENT to Quiet de-energize the corresponding alarm relay. If
The condition that caused the alarm still exists
When the unit is returned to “Running” mode,
The alarm relay will again energize.
Alarm Condition Momentarily displayed to indicate the alarm
Alarm Cleared has been cleared.
The unit automatically advances to the next
menu.
Sponsler V6.13 MS197 To check that no other alarm condition exists,
Lock/Unlock? press to backup to the check alarm option.
Sponsler V6.13 MS197
Check Alarm?
No Alarm Condition Momentarily displayed to indicate that no alarm conditions exist.
The unit will automatically advance to the next menu.
Sponsler V6.13 MS197
Lock/Unlock?
ENT
B
A
A
A
ENT
B
ENT
A
A
A
ENT