Owner manual
1. Refer to the exploded view drawings on pages 24-27. Find the four-digit item number of the part that needs replaced. Item
numbers are listed on the exploded drawings.
2. In the red Owner’s Information Packet supplied with the meter, you will nd a computer printout titled Parts List. The Parts
List lists each item number alongside a ve-digit part number. The part number identies the specic individual piece, kit, or
complete assembly used to assemble that particular meter.
3. Contact your distributor and give them the ve-digit part number. Your
distributor will use it to nd the correct component for your meter.
Always check www.lcmeter.com for
the most current version of manual
M610 - Bill of Materials for LC meters.
Product ows through
meter but register does not
record correctly
A. Adjuster not properly calibrated.
B. Incorrect gear plate or gear ratio has been installed.
C. Air is in the system.
No ow through meter
A. Faulty non-functioning pump.
B. Valve not open or not functioning.
C.
Meter “frozen” due to build-up of chemical “salts” or foreign material inside
metering chamber. Clean the meter and inspect for damage.
Meter runs too slowly
A. Valve internal mechanism faulty. Valve does not open fully.
B.
Meter gears or rotors partially “salted” enough to slow up rotation of parts.
Clean the meter.
C. Downstream restriction.
D. Clogged strainer basket.
The meter counts down in
reverse (the meter numbers
decrease)
Reverse the direction of ow by reversing the adjuster drive gear. See
Reversing the Meter Registration on page 10.
23