Install E3650-E3651 Series Owner manual

16

Neptune Meter Compensated
Insert cotter
pin
Insert cotter
pin
Bolt plate
and flange
to register
Place adapter
on drive
shaft
Bolt flange
to meter
Place fork
and extension
on end of
adapter
LectroCount LCR-II
Gallons
Neptune Meter
Insert cotter
pin
Bolt down
bracket to
meter
Place fork
and extension
on drive shaft
Lower register
and bolt onto
bracket
LectroCount LCR-II
Gallons









 See Warning on pg.
14.
 
 

 
 

 


 

 



 

 

 

 
 

 
Installation kits 82641 (E-26 series) & 82642 (E-36
series) are specically designed for previously temperature
compensated Neptune meters.
Apply anti-seize to all bolt threads to ensure
easy removal at a later date.
ApplyAnti-seize
When the register is lowered onto a Neptune meter, make sure
the drive fork is not pressed against the star gear on the meter.
There must be a small gap between these two parts. To lower
the star gear, loosen the set screw on the side of the star gear.
Failure to do so will eventually damage the internal pulser and/
or the meter gear train.
StarGearandDriveFork


