Installation E3655-E3656 Owner's manual

23
OPTICAL AIR & VAPOR ELIMINATORS
Optical Air Eliminator:

Optical Vapor Eliminator:

3
S3
S3 Solenoid
Optical Sensor
LectroCount LCR-II
Gallons
Meter System with Optical Vapor Eliminator
Meter System with Optical Air Eliminator
Optical Air and Vapor Eliminator
Installations


are bolted onto the strainer and wired to the LCR-II
at the factory. Optical air and vapor eliminators can
also be ordered separately and installed onto meter


air and vapor eliminator. Instructions for wiring optical air
and vapor eliminators to the LCR-II are provided on this
page.
Materials needed for wiring valves: Not supplied
with the air or vapor eliminator
 
 
conduit connectors or cable glands
 
To wire optical air and vapor eliminators to the
LCR-II:
1. Attach cable glands and/or conduit connectors to the S3
solenoid valve, the optical sensor, and the LCR ports.
 
weatherproof conduit cut-to-length from the S3 solenoid
to a LCR-II port.
3. Run the weatherproof conduit between the S3 solenoid-
operated valve and the LCR-II housing. Pull the wires
through the ports, and tighten the connectors. Liquid
Controls recommends running the optical sensor wire
through weatherproof conduit as well.
 
operated valve terminals and to terminals 52 and 53 on

5. Connect the optical sensor wires to terminals 54, 55, and

Disconnect the power before working on the CPU board.
Disconnect Power