Installation E3655-E3656 Owner's manual

22
VALVES
VALVES WITH 110VAC SOLENOIDS
In order for the LectroCount LCR-II to control valves with
solenoids on 110 VAC circuits, you must install a relay


Switch: SPST (single pole, single throw)
Switch Position
Contact Rating: Greater than maximum current
of solenoid
Voltage: +12 VDC
Materials needed for wiring valves with 110 VAC
solenoids: Not supplied with the valve
 
 
 
conduit connectors or cable glands
 
84040 Board
To wire 110 VAC solenoids to the LCR-II:
1. Turn off all 100 VAC circuits before beginning the
installation.
 
110 solenoid power supply circuit.
3. Connect the relay switch on the S1 power supply circuit

4. Connect the relay switch on the S2 power supply circuit

Turn off all 110VAC circuits before beginning
the installation.
Disconnect Power (110VAC)