Setup Owner manual

66
LCP File Server
Screen 1: LCP File Server
The LCP File Server application provides access to the
hard drivers in the DMS i1000 from the DMS i1000 Lap
Pad or other computer systems.
When the application is initialized, a copyright notice will
display for approximately two seconds. Depending on the
contents of the DMS i1000 internal ash card, the display
will remain on Screen 1 shown to the right or advance to
Screen 5 on page 69.
To setup the LCP File Server, press Init (F5) to advance
to Screen 2 shown below. To exit from this application,
press ALT and ESC together to return to DMS i1000Menu
on page 16.
Screen 2a: Setup LCP File Server (1/2)
Language is used to select the user interface language
that will display on the DMS i1000 Lap Pad for the LCP
File Server application. Press ENTER to open a list box
window containing a list of languages available. Move
the pointer to the desired language and press ENTER
to accept.
Number of File Handles is the number of les that the
LCP File Server will allow opened at one time on the
DMS i1000 computer. The default value for this eld is 3,
however, if the ofce computer needs access to more than
three les simultaneously, this eld can be changed to a
larger value. Press ENTER to open a eld edit window
and enter a value from 3 to 255.
LCP Node Address is the address of the DMS i1000
computer that the ofce computer will refer to when
sending an LCP File Server request (using a wireless
transmitter). This eld can contain any value from 1 to
255, and should match the value being used by the ofce
computer that is accessing the les on the DMS i1000
computer. This value should be unique for each DMS
i1000 system. For example, each vehicle with a DMS
i1000 system would be assigned a unique LCP Node
Address so the ofce computer can identify which vehicle
it is communicating with.
Press ENTER to open a eld edit window and enter the
desired value.
Port shows the communications port assigned to the le
server along with its baud rate.
Press Next (F1) to advance to Screen 2b on page 67.
Press Port (F3) to advance to Screen 3 on page 68.
Press Vers (F4) to advance to the DMS i1000 About
Display on page 12.
Press Srvr (F5) to advance to Screen 5 on page 69.
LCP File Server (DMS i1000)
v1.00
Welcome to LCP File Server!
To set up the le server, go
to the SETUP LCP FILE SERVER
screen by pressing F5/Init.
(1/2)
English
3
1
COM1 at 115200 Baud
SETUP LCP FILE SERVER
Language:
Number of File Handles:
LCP Node Address:
Port:
Next Port Vers Srvr