Setup Owner manual

48
Screen 11b: Diagnostics (2/2)
The rst 3 lines indicate software part numbers and
versions in use by the LectroCount.
Supply Voltage represents the current voltage being
supplied to the system. If supply voltage is greater than
17 volts, this reading will be inaccurate.
Press Cnfg (F4) to return to Screen 7 on page 28. Move
pointer to Security and press enter to advance to Screen
12 on page 49.
Screen 11a: Diagnostics (1/2)
Diagnostics
Diagnostics screens contain LectroCount diagnostic
information.
Pulser Faults represents number of false or missing
pulses detected during last delivery.
Gross Count indicates current non-compensated amount
passed through the metering device for the current
delivery.
Flow Rate indicates the current ow rate through the
metering device.
Unit of Measure indicates unit of measurement and Flow
Rate Base the time unit used by the ow rate.
Press Next (F1) to advance to Screen 11b shown
below.
(1/2) 1
0
48.8
0.0
Gallons
Per Minute
DIAGNOSTICS
Pulser Faults:
Gross Count:
Flow Rate:
Unit of Measure:
Flow Rate Base:
Next Cnfg Main
(2/2) 1
SR210v4.03
SL200v4.00
ST200v1.06
13.5
DIAGNOSTICS
Software Revision:
Language Revision:
Ticket Revision
Supply Voltage
Prev Cnfg Main