Setup Owner manual

20
Main Menu
Screen 2: Main Menu
Main Menu is the launch point for system setup, calibration,
and conguration. Items appearing on the Main Menu are
typically used for initial setup and conguration of the
system but may be reset should the system or application
change.
By default, the pointer position will be the rst available
function on the screen. To move pointer from Setup
Network to another line, use up or down arrow of the
DMS i1000 Lap Pad. The up arrow is on shares T key
and down arrow shares Y key.
Setup Network
Advances display to Screen 3 on page 21.
System Parameters
Advances display to Screen 6a on page 26.
Congure LCR#
Advances display to Screen 7 on page 28.
Save Conguration
Advances display to Screen 14 on page 51.
Load Conguration
Advances display to Screen 15 on page 52.
Dlvy appears above function key F1. Press Dlvy (F1) to
advance to Screen 19a on page 54.
LCR# appears above function key F4. Press LCR# (F4)
to open a list box window with options for selecting an
LCR to communicate with.
Press Esc to exit list box window. Move pointer to Setup
Network and press ENTER to advance to Screen 3 on
page 21.
Screen 1: Program Initialization
When the LCRHost application is initialized at start-
up, screen to the right appears. This screen contains
information about the operating software. The rst line
contains program name and revision.
The message shown in lines 4-7 which appear after the
introduction lines, will then appear under the following
condition:
LCRHost detects that the LCRConfg.slf le does not
exist.
If system was already congured, the display will advance
to Screen 19a: Preset and Delivery (1/7) on page 54.
If communication cannot be established with the LCR,
then display will show Screen 20: Device Not Found
on page 59.
If this is the initial set and conguration of the system,
press Main (F5) to advance to Screen 2 shown below.
LCRHost v1.02
Welcome to LCRHost!
To set up your network, go to
the Main Menu by pressing the
F5/Main key.
Main
LCRHost v1.02
MAIN MENU
Setup Network
System Parameters
Congure LCR #xxx
Save Conguration
Load Conguration
Dlvy LCR#