Manual

17
LCP SETUP CONFIGURATION
Retries:
After an initial failed attempt, the number of attempts the computer
will try to make a connection with the wireless communication network
before timing out. (1 is the default value)
Timeout (ms):
The amount of time the computer will wait for a response once a signal
is sent to a wireless network, before timing out. (2000 is the default
value).
IP Cong:
Clicking the button activates IP Conguration settings.
Serial Cong:
Clicking the button activates Serial Conguration settings.
Local IP Port:
A port where TCP/IP communication can be heard. To get around
existing rewalls, your ofce PC will need to be congured so that TCP
data is accepted at this port number.
LCP Setup
LCP Setup sets up the communication link at your PC or server in the ofce, conguring the ofce computer
for wireless communication. LCP Setup contains settings for IP congurations (Wi and cellular) and serial
congurations (radio and direct serial cable). For successful data transmission, the settings in LCP Setup must be
congured to match the communication settings of the DMSs, LCR 600s, and wireless transmission devices in the LC
fueling network. LCP Setup includes a Test tab, where connection between the computer and a specic DMS or LCR
600 (or another computer) can be tested.
LCP Setup - Conguration
Value must match value in the cell modem’s internal setting
(see cell modem manual for setting its IP port). Liquid Controls
recommends 7050 for the value. It is not a common IP Port number
used by other programs such as ftp and email applications.
Network Node:
The LCP network node number of the device the computer is communicating with. 1-255 range
Network IP Address:
The IP address of the device the computer is communicating with, using TCP/IP protocol
Network IP Port:
The IP port number of the device the computer is communicating with, using TCP/IP protocol
Port Name:
The computer’s serial communication port the data communication device is connected to.
TX Enable:
The setting for the serial signal transmit and receive handshake technique to the data communication device. None is the default setting.
None • !RTS • RTS • !DTR • DTR • !RTS!DTR • RTSDTR
Baud:
The communication speed. This value should match the wireless device. 57600 is the standard communication speed, but check your
wireless device specications to ensure the proper selection.
115200 • 57600 • 19200 • 9600 • 4800 • 2400
Cancel
Closes the window without saving.
Save
Saves settings that appear in the window.
Done
Saves settings that appear in the window and closes the window.
LCP SETUP - SETUP