Safety data sheet

Safety data sheet according to Regulation (EC) No 1907/2006, Annex II
Revised on / Version: 22.07.2013 / 0002
Replaces revision of / Version: 19.09.2012 / 0001
Valid from: 22.07.2013
PDF print date: 28.05.2014
BIKE Kettenoel Wet Lube 100 ml Art.: 6052
Remove contaminated clothing and protective equipment before entering areas in which food is consumed.
Eye/face protection:
Tight fitting protective goggles (EN 166) with side protection, with danger of projections.
Skin protection - Hand protection:
Chemical resistant protective gloves (EN 374).
Recommended
Protective nitrile gloves (EN 374)
Minimum layer thickness in mm:
0,3
Permeation time (penetration time) in minutes:
>= 480
Protective hand cream recommended.
Skin protection - Other:
Usual protective working garments
Respiratory protection:
Normally not necessary.
Thermal hazards:
Not applicable
Additional information on hand protection - No tests have been performed.
In the case of mixtures, the selection has been made according to the knowledge available and the information about the contents.
Selection of materials derived from glove manufacturer's indications.
Final selection of glove material must be made taking the breakthrough times, permeation rates and degradation into account.
Selection of a suitable glove depends not only on the material but also on other quality characteristics and varies from manufacturer to
manufacturer.
In the case of mixtures, the resistance of glove materials cannot be predicted and must therefore be tested before use.
The exact breakthrough time of the glove material can be requested from the protective glove manufacturer and must be observed.
8.2.3 Environmental exposure controls
No information available at present.
SECTION 9: Physical and chemical properties
9.1 Information on basic physical and chemical properties
Physical state: Liquid
Colour: Yellow
Odour: Characteristic
Odour threshold: Not determined
pH-value: n.a.
Melting point/freezing point: Not determined
Initial boiling point and boiling range: Not determined
Flash point: >250 °C (DIN 51376 (Cleveland, open cup))
Evaporation rate: Not determined
Flammability (solid, gas): n.a.
Lower explosive limit: n.a.
Upper explosive limit: n.a.
Vapour pressure: Not determined
Vapour density (air = 1): Not determined
Density: 0,92 g/cm3 (15°C, DIN 51757)
Bulk density: n.a.
Solubility(ies): Not determined
Water solubility: Insoluble
Partition coefficient (n-octanol/water): Not determined
Auto-ignition temperature: No
Decomposition temperature: Not determined
Viscosity: 113 mm2/s (40°C, DIN 51562)
Explosive properties: Product is not explosive.
Oxidising properties: No
9.2 Other information
Page 4 of 9