Safety data sheet

Safety data sheet according to Regulation (EC) No 1907/2006, Annex II
Revision date / version: 21.08.2015 / 0012
Replacing version dated / version: 08.05.2015 / 0011
Valid from: 21.08.2015
PDF print date: 24.08.2015
Scheiben-Reiniger 1 L
Art.: 1514
Tight fitting protective goggles with side protection (EN 166).
Skin protection - Hand protection:
Chemical resistant protective gloves (EN 374).
Recommended
Safety gloves made of butyl (EN 374)
Minimum layer thickness in mm:
0,5
Permeation time (penetration time) in minutes:
480
Protective hand cream recommended.
The breakthrough times determined in accordance with EN 374 Part 3 were not obtained under practical conditions.
The recommended maximum wearing time is 50% of breakthrough time.
Skin protection - Other:
Protective working garments (e.g. safety shoes EN ISO 20345, long-sleeved protective working garments).
Respiratory protection:
Normally not necessary.
Thermal hazards:
Not applicable
Additional information on hand protection - No tests have been performed.
In the case of mixtures, the selection has been made according to the knowledge available and the information about the contents.
Selection of materials derived from glove manufacturer's indications.
Final selection of glove material must be made taking the breakthrough times, permeation rates and degradation into account.
Selection of a suitable glove depends not only on the material but also on other quality characteristics and varies from manufacturer to
manufacturer.
In the case of mixtures, the resistance of glove materials cannot be predicted and must therefore be tested before use.
The exact breakthrough time of the glove material can be requested from the protective glove manufacturer and must be observed.
8.2.3 Environmental exposure controls
No information available at present.
SECTION 9: Physical and chemical properties
9.1 Information on basic physical and chemical properties
Physical state: Liquid
Colour: Light yellow, Light green
Odour: Lemon
Odour threshold: Not determined
pH-value: 7,2 (20°C, DIN 19268)
Melting point/freezing point: Not determined
Initial boiling point and boiling range: ~100 °C
Flash point: Not determined
Evaporation rate: Not determined
Flammability (solid, gas): No
Lower explosive limit: Not determined
Upper explosive limit: Not determined
Vapour pressure: Not determined
Vapour density (air = 1): Not determined
Density: 1,00 g/cm3 (20°C, DIN 51757)
Bulk density: n.a.
Solubility(ies): Not determined
Water solubility: Mixable
Partition coefficient (n-octanol/water): Not determined
Auto-ignition temperature: No
Decomposition temperature: Not determined
Viscosity: Not determined
Explosive properties: Product is not explosive.
Oxidising properties: No
9.2 Other information
Page 5 of 11