Safety data sheet

Safety data sheet according to Regulation (EC) No 1907/2006, Annex II
Revision date / version: 21.08.2015 / 0011
Replacing version dated / version: 30.07.2015 / 0010
Valid from: 21.08.2015
PDF print date: 26.08.2015
Motorbike Multi-Spray 200 mL
Art.: 1513
Thermal hazards:
Not applicable
Additional information on hand protection - No tests have been performed.
In the case of mixtures, the selection has been made according to the knowledge available and the information about the contents.
Selection of materials derived from glove manufacturer's indications.
Final selection of glove material must be made taking the breakthrough times, permeation rates and degradation into account.
Selection of a suitable glove depends not only on the material but also on other quality characteristics and varies from manufacturer to
manufacturer.
In the case of mixtures, the resistance of glove materials cannot be predicted and must therefore be tested before use.
The exact breakthrough time of the glove material can be requested from the protective glove manufacturer and must be observed.
8.2.3 Environmental exposure controls
No information available at present.
SECTION 9: Physical and chemical properties
9.1 Information on basic physical and chemical properties
Physical state: Aerosol, Substance: Liquid
Colour: Brown, Clear
Odour: Characteristic
Odour threshold: Not determined
pH-value: Not determined
Melting point/freezing point: Not determined
Initial boiling point and boiling range: n.a.
Flash point: n.a.
Evaporation rate: Not determined
Flammability (solid, gas): Not determined
Lower explosive limit: Not determined
Upper explosive limit: Not determined
Vapour pressure: Not determined
Vapour density (air = 1): Not determined
Density: 0,881 g/ml (20°C, Active substance )
Bulk density: Not determined
Solubility(ies): Not determined
Water solubility: Insoluble
Partition coefficient (n-octanol/water): Not determined
Auto-ignition temperature: Not determined
Decomposition temperature: Not determined
Viscosity: 17 mm2/s (40°C, Active substance )
Explosive properties: Not determined
Oxidising properties: No
9.2 Other information
Miscibility: Not determined
Fat solubility / solvent: Not determined
Conductivity: Not determined
Surface tension: Not determined
Solvents content: Not determined
SECTION 10: Stability and reactivity
10.1 Reactivity
Pressure increase will result in danger of bursting.
10.2 Chemical stability
Stable with proper storage and handling.
10.3 Possibility of hazardous reactions
No dangerous reactions are known.
10.4 Conditions to avoid
Heating, open flame, ignition sources
Pressure increase will result in danger of bursting.
Page 7 of 15