Safety data sheet

Safety data sheet according to Regulation (EC) No 1907/2006, Annex II
Revision date / version: 21.08.2015 / 0014
Replacing version dated / version: 09.04.2015 / 0013
Valid from: 21.08.2015
PDF print date: 23.08.2015
Motorbike Cleaner 1 L
Art.: 1509
Environment - sewage
treatment plant
PNEC 4 mg/l
Environment - sediment,
freshwater
PNEC 0,386 mg/kg dw
Environment - sediment,
marine
PNEC 0,0386 mg/kg dw
Environment - soil PNEC 0,0185 mg/kg dw
Propane-1,2-diol
Area of application Exposure route /
Environmental
compartment
Effect on health Descriptor Value Unit Note
Workers / employees Human - inhalation Long term, systemic
effects
DNEL 168 mg/m3
Workers / employees Human - inhalation Long term, local effects DNEL 10 mg/m3
Consumer Human - dermal Long term, systemic
effects
DNEL 213 mg/kg
Consumer Human - inhalation Long term, systemic
effects
DNEL 50 mg/m3
Consumer Human - oral Long term, systemic
effects
DNEL 85 mg/kg
Consumer Human - inhalation Long term, local effects DNEL 10 mg/m3
Environment - freshwater PNEC 260 mg/l
Environment - marine PNEC 26 mg/l
Environment - sewage
treatment plant
PNEC 2000 mg/l
Environment - sediment,
freshwater
PNEC 572 mg/kg
Environment - sediment,
marine
PNEC 57,2 mg/kg
Environment - soil PNEC 50 mg/kg
Environment - water,
sporadic (intermittent)
release
PNEC 183 mg/l
8.2 Exposure controls
8.2.1 Appropriate engineering controls
Ensure good ventilation. This can be achieved by local suction or general air extraction.
If this is insufficient to maintain the concentration under the WEL or AGW values, suitable breathing protection should be worn.
Applies only if maximum permissible exposure values are listed here.
8.2.2 Individual protection measures, such as personal protective equipment
General hygiene measures for the handling of chemicals are applicable.
Wash hands before breaks and at end of work.
Keep away from food, drink and animal feedingstuffs.
Remove contaminated clothing and protective equipment before entering areas in which food is consumed.
Eye/face protection:
Tight fitting protective goggles (EN 166) with side protection, with danger of projections.
Skin protection - Hand protection:
Protective PVC gloves (EN 374)
Protective gloves of polyurethane (EN 374)
Rubber gloves (EN 374).
Protective nitrile gloves (EN 374)
Minimum layer thickness in mm:
0,4
Permeation time (penetration time) in minutes:
> 480
The breakthrough times determined in accordance with EN 374 Part 3 were not obtained under practical conditions.
The recommended maximum wearing time is 50% of breakthrough time.
Protective hand cream recommended.
Page 5 of 14