Certifications 2

Safety data sheet according to Regulation (EC) No 1907/2006, Annex II
Revision date / version: 18.07.2019 / 0021
Replacing version dated / version: 29.06.2018 / 0020
Valid from: 18.07.2019
PDF print date: 14.06.2021
Motorinnenkonservierer
Prevent surface and ground-water infiltration, as well as ground penetration.
Prevent from entering drainage system.
6.3 Methods and material for containment and cleaning up
If spray or gas escapes, ensure ample fresh air is available.
Active substance:
Soak up with absorbent material (e.g. universal binding agent) and dispose of according to Section 13.
6.4 Reference to other sections
For personal protective equipment see Section 8 and for disposal instructions see Section 13.
SECTION 7: Handling and storage
In addition to information given in this section, relevant information can also be found in section 8 and 6.1.
7.1 Precautions for safe handling
7.1.1 General recommendations
Ensure good ventilation.
Keep away from sources of ignition - Do not smoke.
Do not use on hot surfaces.
Eating, drinking, smoking, as well as food-storage, is prohibited in work-room.
Observe directions on label and instructions for use.
Use working methods according to operating instructions.
7.1.2 Notes on general hygiene measures at the workplace
General hygiene measures for the handling of chemicals are applicable.
Wash hands before breaks and at end of work.
Keep away from food, drink and animal feedingstuffs.
Remove contaminated clothing and protective equipment before entering areas in which food is consumed.
7.2 Conditions for safe storage, including any incompatibilities
Keep out of access to unauthorised individuals.
Not to be stored in gangways or stair wells.
Store product closed and only in original packing.
Do not store with oxidizing agents.
Observe special regulations for aerosols!
Observe special storage conditions.
Keep protected from direct sunlight and temperatures over 50°C.
Store in a well ventilated place.
7.3 Specific end use(s)
No information available at present.
SECTION 8: Exposure controls/personal protection
8.1 Control parameters
Workplace exposure limit (WEL) of the total hydrocarbon solvent content of the mixture (RCP method according to EH40):
600 mg/m3
Chemical Name
Hydrocarbons, C6-C7, n-alkanes, isoalkanes, cyclics, <5% n-hexane
Content %:2,5-
<10
WEL-TWA: 600 mg/m3 WEL-STEL: --- ---
Monitoring procedures: - Compur - KITA-187 S (551 174)
BMGV: --- Other information: (OEL acc. to RCP-method,
paragraphs 84-87, EH40)
Chemical Name
Oil mist, mineral
Content %:
WEL-TWA: 5 mg/m3 (Mineral oil, excluding metal
working fluids, ACGIH)
WEL-STEL: --- ---
Monitoring procedures: - Draeger - Oil Mist 1/a (67 33 031)
BMGV: --- Other information: ---
Chemical Name
Butane
Content %:
WEL-TWA: 600 ppm (1450 mg/m3) WEL-STEL: 750 ppm (1810 mg/m3) ---
Monitoring procedures: - Compur - KITA-221 SA (549 459)
- OSHA PV2010 (n-Butane) - 1993
Page 4 of 14