Safety data sheet

Safety data sheet according to Regulation (EC) No 1907/2006, Annex II
Revision date / version: 21.08.2015 / 0028
Replacing version dated / version: 24.06.2015 / 0027
Valid from: 21.08.2015
PDF print date: 23.08.2015
MOTOR CLEAN 500 mL
Art.: 1019
Selection of a suitable glove depends not only on the material but also on other quality characteristics and varies from manufacturer to
manufacturer.
In the case of mixtures, the resistance of glove materials cannot be predicted and must therefore be tested before use.
The exact breakthrough time of the glove material can be requested from the protective glove manufacturer and must be observed.
8.2.3 Environmental exposure controls
No information available at present.
SECTION 9: Physical and chemical properties
9.1 Information on basic physical and chemical properties
Physical state: Liquid
Colour: Yellow, Brown
Odour: Characteristic
Odour threshold: Not determined
pH-value: n.a.
Melting point/freezing point: Not determined
Initial boiling point and boiling range: Not determined
Flash point: 63 °C
Evaporation rate: Not determined
Flammability (solid, gas): Not determined
Lower explosive limit: 0,6 Vol-% (Hydrocarbons, C10-C13, n-alkanes, isoalkanes, cyclics,
aromatics (2-25%))
Upper explosive limit: 6,1 Vol-% (Hydrocarbons, C10-C13, n-alkanes, isoalkanes, cyclics,
aromatics (2-25%))
Vapour pressure: Not determined
Vapour density (air = 1): Vapours heavier than air.
Density: 0,81 g/ml (20°C)
Bulk density: Not determined
Solubility(ies): Not determined
Water solubility: Insoluble
Partition coefficient (n-octanol/water): Not determined
Auto-ignition temperature: 230 °C (DIN 51794, Ignition temperature Hydrocarbons, C10-C13, n-
alkanes, isoalkanes, cyclics, aromatics (2-25%))
Decomposition temperature: Not determined
Viscosity: <7 mm2/s (40°C)
Explosive properties: Not determined
Oxidising properties: No
9.2 Other information
Miscibility: Not determined
Fat solubility / solvent: Not determined
Conductivity: Not determined
Surface tension: Not determined
Solvents content: Not determined
SECTION 10: Stability and reactivity
10.1 Reactivity
The product has not been tested.
10.2 Chemical stability
Stable with proper storage and handling.
10.3 Possibility of hazardous reactions
No decomposition if used as intended.
10.4 Conditions to avoid
See also section 7.
Open flame, ignition sources
10.5 Incompatible materials
See also section 7.
Avoid contact with strong oxidizing agents.
10.6 Hazardous decomposition products
Page 7 of 13