Safety data sheet

Safety data sheet according to Regulation (EC) No 1907/2006, Annex II
Revised on / Version: 28.08.2014 / 0016
Replaces revision of / Version: 03.12.2013 / 0015
Valid from: 28.08.2014
PDF print date: 29.08.2014
MOTOR PROTECT 500 mL
Art.: 1018
In the case of mixtures, the selection has been made according to the knowledge available and the information about the contents.
Selection of materials derived from glove manufacturer's indications.
Final selection of glove material must be made taking the breakthrough times, permeation rates and degradation into account.
Selection of a suitable glove depends not only on the material but also on other quality characteristics and varies from manufacturer to
manufacturer.
In the case of mixtures, the resistance of glove materials cannot be predicted and must therefore be tested before use.
The exact breakthrough time of the glove material can be requested from the protective glove manufacturer and must be observed.
8.2.3 Environmental exposure controls
No information available at present.
SECTION 9: Physical and chemical properties
9.1 Information on basic physical and chemical properties
Physical state: Liquid
Colour: Brown
Odour: Characteristic
Odour threshold: Not determined
pH-value: Not determined
Melting point/freezing point: Not determined
Initial boiling point and boiling range: Not determined
Flash point: >160 °C
Evaporation rate: Not determined
Flammability (solid, gas): n.a.
Lower explosive limit: Not determined
Upper explosive limit: Not determined
Vapour pressure: Not determined
Vapour density (air = 1): Not determined
Density: 0,888 g/ml (20°C)
Bulk density: n.a.
Solubility(ies): Not determined
Water solubility: Insoluble
Partition coefficient (n-octanol/water): Not determined
Auto-ignition temperature: Not determined
Decomposition temperature: Not determined
Viscosity: 84,5 mm2/s (40°C)
Explosive properties: Product is not explosive.
Oxidising properties: No
9.2 Other information
Miscibility: Not determined
Fat solubility / solvent: Not determined
Conductivity: Not determined
Surface tension: Not determined
Solvents content: Not determined
SECTION 10: Stability and reactivity
10.1 Reactivity
The product has not been tested.
10.2 Chemical stability
Stable with proper storage and handling.
10.3 Possibility of hazardous reactions
No dangerous reactions are known.
10.4 Conditions to avoid
See also section 7.
Heating, open flame, ignition sources
10.5 Incompatible materials
See also section 7.
Avoid contact with strong oxidizing agents.
10.6 Hazardous decomposition products
Page 5 of 11