Safety data sheet

Safety data sheet according to Regulation (EC) No 1907/2006, Annex II
Revision date / version: 21.08.2015 / 0005
Replacing version dated / version: 15.10.2012 / 0004
Valid from: 21.08.2015
PDF print date: 23.08.2015
OIL ADDITIV 125 mL
Art.: 1011
Avoid formation of oil mist.
Avoid contact with eyes or skin.
If applicable, caution - risk of slipping.
Do not carry cleaning cloths soaked in product in trouser pockets.
6.2 Environmental precautions
If leakage occurs, dam up.
Resolve leaks if this possible without risk.
Prevent from entering drainage system.
Prevent surface and ground-water infiltration, as well as ground penetration.
6.3 Methods and material for containment and cleaning up
Soak up with absorbent material (e.g. universal binding agent) and dispose of according to Section 13.
6.4 Reference to other sections
For personal protective equipment see Section 8 and for disposal instructions see Section 13.
SECTION 7: Handling and storage
In addition to information given in this section, relevant information can also be found in section 8 and 6.1.
7.1 Precautions for safe handling
7.1.1 General recommendations
Ensure good ventilation.
Do not heat to temperatures close to flash point.
Eating, drinking, smoking, as well as food-storage, is prohibited in work-room.
Observe directions on label and instructions for use.
7.1.2 Notes on general hygiene measures at the workplace
General hygiene measures for the handling of chemicals are applicable.
Wash hands before breaks and at end of work.
Keep away from food, drink and animal feedingstuffs.
Remove contaminated clothing and protective equipment before entering areas in which food is consumed.
7.2 Conditions for safe storage, including any incompatibilities
Store product closed and only in original packing.
Not to be stored in gangways or stair wells.
Solvent resistant floor
Do not store with oxidizing agents.
Store in a well ventilated place.
Protect from direct sunlight and warming.
7.3 Specific end use(s)
No information available at present.
SECTION 8: Exposure controls/personal protection
8.1 Control parameters
Chemical Name
Oil mist, mineral
Content %:
WEL-TWA: 5 mg/m3 (ACGIH) WEL-STEL: 10 mg/m3 (ACGIH) ---
Monitoring procedures: - Draeger - Oil 10/a-P (67 28 371)
- Draeger - Oil Mist 1/a (67 33 031)
BMGV: --- Other information: ---
Chemical Name
Baseoil - unspecified
Content %:
WEL-TWA: 300 mg/m3 (AGW) WEL-STEL: 2(II) (AGW) ---
Monitoring procedures: - Draeger - Hydrocarbons 2/a (81 03 581)
- Draeger - Hydrocarbons 0,1%/c (81 03 571)
- Compur - KITA-187 S (551 174)
BMGV: --- Other information: ---
Chemical Name
Molybdenum disulphide
Content %:
WEL-TWA: 10 mg/m3 (molybdenum insoluble
compounds, as Mo)
WEL-STEL: 20 mg/m3 (molybdenum insoluble
compounds, as Mo)
---
Page 3 of 10