Use and Care Manual

lci1.com 574-537-8900 CCD-0001583 Rev. 07.10.18

360 Siphon

Aftermarket Manual

4� Dry t all parts prior to adding any adhesive/sealant.

5� Apply a small amount of adhesive/sealant around the

perimeter of the funnel that ts into the lid and insert (Fig.2).

Fig.2

6� If applicable, apply a small amount of adhesive/sealant

around the top of the collar (Fig.3) and attach to the lid.

Fig.3

7� Apply adhesive/sealant to the bottom of the collar (Fig.4) and

seal the 360 Siphon assembly to the existing base, making

sure the funnel extends into the stack pipe.

Fig.4

Cap 1 (Fig�5, Fig�6 and Fig�7)

1� Remove the lid by removing the single screw on the top.

2� Use a saw to cut off the 8 legs and lid support.

lid

base

Fig.5

Fig.6

adhesive/sealant

underneath

Fig.7