S�����® P���� A����� OWNER'S MANUAL Rev: 08.29.
TABLE OF CONTENTS Operation 2 2 3 3 4 5 6 6 9 Extending the Awning Adjusting Pitch Fabric Care Manual Override Solera Power® Awning Assembly Webpage Solera Power® Awning Components Webpage Variant Code Information Ordering Replacement Fabric Operation Extending the Awning 1. Verify the battery is fully charged and connected to the electrical system. 2. Locate the locking latch (Fig. 1), if equipped, on the drive side awning arm and unlock the latch (Fig. 2).
Retracting the Awning 1. Verify the battery is fully charged and connected to the electrical system. 2. Press and hold RETRACT (Fig. 2B) until the awning is retracted completely. 3. Locate the locking latch (Fig. 2), if equipped, on the drive side awning arm and lock the latch to secure the awning in place (Fig. 1). NOTE: This latch is optional. If not installed, awning is secured and ready for transportation.
Manual Override In the event of power loss or motor failure, the awning can be extended and retracted manually. Perform the following procedure to manually retract the awning. 1. Remove rubber plug from the power head assembly exposing the manual override nut on the motor (Fig. 7A). NOTE: The power head is always located on the right side of the awning as it is viewed from outside of the coach. 2.
SOLERA® POWER AWNING ASSEMBLY WEBPAGE AWNINGS End Cap Wax Screw Idler Head Assembly Roll Bar Drive Head Assembly Rubber Grommet Motor Power Feed Cable Gas Strut Support Arm Assembly Center Support Assembly (Ships Loose) Rev: 08.29.
SOLERA® POWER AWNING COMPONENTS WEBPAGE Variant Code Information The variant code on Lippert products can assist LCI customers in obtaining additional information about the product and its components. For replacement part information, locate the variant code as outlined below and call LCI customer service at 574-537-8900. Roll bar Variant Code A C B D Callout A B C D E F Rev: 08.29.
G L H I M J K P N O Callout G H I J K L Part # 266156 299630 118043 266148 266155 275071 2661301 M 2661302 N 299419 O 178231 Drive Head Gear Kit 353964 P Rev: 08.29.
B A C D E Callout A B C D E White Part # Black Part # 295742 295743 260294 266169 281152 281154 280343 260282 286576 282484 289373 289374 Description Support Arm Assembly (Short, 61") (One Arm) Support Arm Assembly (Pitched, 66 1⁄8") (One Arm) Support Arm Assembly (Flat, 69") (One Arm) Gas Strut; 26"; 124 LBS (for Short and Flat Arm assemblies) Gas Strut; 124 - 144 LBS (for Pitched Arm assemblies) Screw - #14 - 10 x 1 ½ (arms to coach) Star Washer (for Gas Strut) Awning Center Support Assembly NOTE:
B A F E Callout A B White Part # Black Part # 266149 266132 285499 C D E F Rev: 08.29.2014 D C 285500 280570 280565 280564 285079 280567 280566 285077 273007 275070157 275070353 266138481 266139337 266139429 2750701692 2750701888 2661382017 2661391872 2661391964 Description Motor Screw ¼ - 20 x ¼ IHWH 2N SLF ST (motor to mount) Switch Kit (Switch, Plate, and Harness) Wire Harness Only Switch Plate Only Switch Only Bezel Spacer Power Feed Wires Wire Cover; 9.
The contents of this manual are proprietary and copyright protected by Lippert Components, Inc. (“LCI”). LCI prohibits the copying or dissemination of portions of this manual unless prior written consent from an authorized LCI representative has been provided. Any unauthorized use shall void any applicable warranty. The information contained in this manual is subject to change without notice and at the sole discretion of LCI. Revised editions are available for free download from www.lci1.com.