S�������� B��� L��� Owner's Manual
SYSTEM DESCRIPTION The Bunk Lift System is designed to raise and lower an unoccupied and unloaded bunk bed integrated into a dinette/bed setting in a stationary recreational vehicle. IMPORTANT!! NOTE: Bed is not to be occupied, loaded or used for cargo storage in any way while being raised or lowered. The dinette/bed setting is not to be occupied during raising or lowering the bunk bed.
CALIBRATION SYNCING 1. 2. 3. 4. Push the calibration button on the receiver three times and hold on the third. Lights will flash back and forth. Push any button on remote. When the remote is synced, lights alternate and then shut off. SETTING STOP POINTS 1. 2. 3. Lower the Bunk Lift into the desired position and press the white calibration button on the receiver once. Raise the Bunk Lift into the desired position and press the white calibration button on the receiver once.
All information contained within may be distributed as a full document only, unless otherwise permitted by explicit consent of Lippert Components Inc. to distribute individual parts. All information contained within is subject to change without notice. New editions will be posted on www.lci1.com and can be downloaded for free. Information contained within is considered factual until made obsolete by a *NEW* revision. Please recycle all obsolete materials.
