User Manual

Rev: 11.04.2014
Page 6
Level Up Troubleshooting Guide
LEVEL-UP
®
(TOWABLE) TROUBLESHOOTING GUIDE
Travel Trailer Operation
Unhooking Instructions
NOTE: Prior to unhitching from the tow vehicle, ensure unit is parked on a level
surface and chock the tires of the unit.
1. Push “On/Off” button to turn system “On” (Green Light).
2. Push “Up” or “Down” arrow to scroll through features to “Manual Mode” in
display.
3. Push “Enter”.
4. Push “Front” button to extend front jacks to the ground until the trailer is
unhitched from the tow vehicle.
NOTE: The Power Tongue Jack SHOULD only be used when storing the trailer.
Auto Level
NOTE: The Power Tongue Jack MUST be retracted prior to starting auto level
sequence (Fig. 6 shows the LCD alert).
Fig. 7
B
C
Callout Description
A Steps 1 + 4 (Front Jacks)
B Step 2 (Left Rear/Roadside Leveling Jack)
C Step 3 (Right Rear/Curbside Leveling Jack)
A
1. After unhitching from tow vehicle press Auto Level (Fig. 1F).
NOTE: In order for hitch recognition feature to function, the auto level sequence
MUST be started with the front of the unit above level.
Auto Level Sequence
1. Front jacks retract, lowering the front of the unit below level, stopping, then
lifting the front end to level the unit front to back. (Fig. 7A).
2. The left side leveling jack extend and raise the roadside of the unit (Fig. 7B).
3. The right side leveling jack extend and raise the curbside of the unit,
beginning side to side leveling (Fig. 7C).
4. The front jacks extend to complete the leveling cycle (Fig. 7A).
NOTE: Additional left to right or front to back leveling may occur if the controller
deems necessary.
NOTE: If the auto level sequence does not happen as stated above, check to
ensure proper manual function in all zones.
Fig. 6