User Manual

Rev: 11.04.2014

Page 5

Level Up Troubleshooting Guide

LEVEL-UP

(TOWABLE) TROUBLESHOOTING GUIDE

Wheel Operation

Auto Level

NOTE: Prior to unhitching from the tow vehicle, ensure unit is

parked on a level surface and to chock the tires of the unit.

1. After unhitching from tow vehicle press Auto Level (Fig. 1F).

NOTE: In order for hitch recognition feature to function, the auto

level sequence MUST be started with the front of the unit

above level.

Auto Level Sequence

1. Front landing gear retract, lowering the front of the unit below

level, stopping, then lifting the front end to level the unit front

to back. (Fig. 4A).

2. The left side leveling jack(s) extend and raise the roadside of

the unit (Fig. 4B).

3. The right side leveling jack(s) extend and raise the curbside of

the unit, beginning side to side leveling (Fig. 4C).

4. The front landing gears extend to complete the leveling cycle

(Fig. 4A).

NOTE: Additional left to right or front to back leveling may occur if

the controller deems necessary.

NOTE: If the auto level sequence does not happen as stated above,

check to ensure proper manual function in all zones.

Hitch Recognition

1. Turn on touch pad.

2. Press the left and right buttons simultaneously (Fig. 5A and 5B).

3. The front of the unit will raise to the height where the auto

level sequence was started.

NOTE: If the auto level sequence was started with the front of the

unit in a below level condition, the Hitch Recognition will

not function and the LCD will display “Feature Disabled”.

In order for hitch recognition feature to function, the auto

level sequence MUST be started with the front of the unit

above level.

Fig. 4

Callout Description

A Steps 1 + 4 (Front Landing Gear)

B Step 2 (Left/Roadside Leveling Jacks)

C Step 3 (Right/Curbside Leveling Jacks)

Fig. 5