Level-Up® Motorhome Leveling Troubleshooting Guide TROUBLESHOOTING GUIDE Rev: 01.13.
TABLE OF CONTENTS Introduction Components Operation 3 3 5 5 5 5 6 6 6 6 7 7 7 8 8 9 Selecting a Site Automatic Leveling Procedure Automatic Leveling Descriptive Logic Safety Features Automatic Safety Shutoff Drive Away Protection System “Emergency Retract" Alarm Calibration and Programming Level Zero Point Calibration For Diesel Units with Air Bag Suspensions ONLY Troubleshooting Error Mode Wiring Diagram Rev: 01.13.
® LEVEL-UP MOTORHOME LEVELING TROUBLESHOOTING GUIDE Introduction The Level-Up® Motorhome Leveling is a 4-point automatic leveling system. Jacks work in like-side pairs to safely and quickly level the coach. Components Fig. 1 - Touchpad A K E B G C F H D I J Callout A B C D E F G H I J K Description Up Arrow - Scrolls up through the menu on LCD. Down Arrow - Scrolls down through the menu on LCD. Enter - Activates modes and procedures indicated on LCD.
® LEVEL-UP MOTORHOME LEVELING TROUBLESHOOTING GUIDE Note: Orientation is imperative for proper operation of the system. The controller and rear sensor must be aligned with the vehicle in the way that is shown on their labels. Fig. 2A Fig. 2 - Controller Fig. 3A Fig. 3 - Rear Sensor Rev: 01.13.
® LEVEL-UP MOTORHOME LEVELING TROUBLESHOOTING GUIDE Operation Selecting a Site When the coach is parked on an excessive slope, the leveling requirements may exceed the jack lift stroke capability. If the coach is parked on an excessive slope, the coach should be moved to a more level surface before the leveling system is deployed. EXCESSIVE SLOPE will appear on the LCD screen if the coach is 3.5 degrees out of level front to rear or side to side. Automatic Leveling Procedure Note: Coach requires 12.
® LEVEL-UP MOTORHOME LEVELING TROUBLESHOOTING GUIDE Safety Features Automatic Safety Shutoff If the control panel is left on and inactive for four minutes it will shut off automatically. To reset the system, the coach ignition must be turned off, then back on, and the ON/OFF button must again be pushed.
® LEVEL-UP MOTORHOME LEVELING TROUBLESHOOTING GUIDE Calibration and Programming Level Zero Point Calibration Before auto leveling features are available, the Level Zero Point must be set. This is the point to which the system will return when an auto leveling cycle is initiated. To set the zero point (controller module must be fully secured in production-intent location) activate the Level Zero Point configuration mode. This mode is enabled by performing the following sequence: 1. Turn panel off. 2.
® LEVEL-UP MOTORHOME LEVELING TROUBLESHOOTING GUIDE Troubleshooting Error Mode A. If an error occurs before or during operation, the error will be displayed in the LCD and an alarm will sound. To reset all error or service displays, push ENTER. B. All normal functions will be disabled when the system is in Error Mode.
Wiring Diagram OEM Air Bag System and Auxiliary Features Rev: 01.13.
The contents of this manual are proprietary and copyright protected by Lippert Components, Inc. (“LCI”). LCI prohibits the copying or dissemination of portions of this manual unless prior written consent from an authorized LCI representative has been provided. Any unauthorized use shall void any applicable warranty. The information contained in this manual is subject to change without notice and at the sole discretion of LCI. Revised editions are available for free download from www.lci1.com.
