User guide

Schwintek in-wall™ Slideout SyStem

winnebago induStrieS - owner’S manual

LIPPERTCOMPONENTS, INC.

Error codes

During operation when an error occurs the board will use the led’s to indicate where the problem

exists.

For motor specic faults the green led will blink 1 time for motor 1, and 2 times for motor 2. The red

led will blink from 2 to 9 times depending on the error code.

The error codes are as follows:

2 Battery drop out: Battery capacity low enough to drop below 6 volts while running

3 Low battery: Voltage below 8 volts at start of cycle

4 High battery: Voltage greater than 18 volts

5 Excessive motor current: High amperage, also indicated by 1 side of slide continually stalling.

6 Motor short circuit: Motor or wiring to motor has shorted out.

8 Hall signal not present: Encoder is not providing a signal. Usually a wiring problem.

9 Hall power short to ground: Power to encoder has been shorted to ground. Usually a wiring

problem.

When an error code is present, the board needs to be re-set. Energizing the extend/retract switch

resets the board. Energize the extend/retract switch again for normal operation.

WARNING!

DO NOT MOVE THE RV UNLESS THE MOTORS ARE PLUGGED IN!

revWNBG2

PAGE 1
LIPPERTCOMPONENTS, INC. Schwintek In-Wall™ Slideout System Winnebago Industries - Owner’s Manual Error codes During operation when an error occurs the board will use the led’s to indicate where the problem exists. For motor specific faults the green led will blink 1 time for motor 1, and 2 times for motor 2. The red led will blink from 2 to 9 times depending on the error code.
PAGE 2
Manual Override - C1 & C2 versions 1. Electronic Manual Override (available on board revision C1 and newer) Locate the circuit board Press the “mode button” six times quickly, press a 7th time and hold for approximately 5 seconds. Mode Button The red and green LED lights will begin to flash, confirming the override mode. Release mode button. Back inside coach; use the normal slide control switch to retract the room. A video demonstrating this technique can be found on the internet.
PAGE 3
Trouble shooting flow chart
PAGE 4
Checking Fuses The Schwintek In-Wall™ Slide requires a minimum of 30 amp fuse. Check the 12 volt fuse box for blown fuses, and replace any if necessary. Consult the rv manufacturers documentation for the location of the 12 volt fuse box, and the location of the Room Slide Controller’s fuse. If the fuse blows immediately upon replacement, there is a problem with the wiring to the In-Wall™ Slide control box. Have qualified service personnel check and repair.