Users Manual Part 1

•
A U ppert Componenui Com pany ®
the general instructions, as necessary, for effectively
interfacing with the device, product or system. Failure to
correctly follow the provided instructions may result in death,
serious personal injury, severe product and/or property
damage, including voiding of the LCI limited warranty.
AWARNING
THE "WARNING" SYMBOL ABOVE IS A SIGN THAT
AN INSTALLATION PROCEDURE HAS A SAFETY
RISK INVOLVED AND MAY CAUSE DEATH OR
SERIOUS PERSONAL INJURY, SEVERE PRODUCT
OR PROPERTY DAMAGE IF NOT PERFORMED
SAFELY AND WITHIN THE PARAMETERS SET
FORTH IN THIS MANUAL.
ACAUTION
Parts List
NOTE : Part numbers are s n for identification purposes
only. Not all parts are ai ab for individual sale. All parts
with a link to the Ta O l:l de Store can be purchased.
AquaFi Kit-781414
•
AquaFi Hotspot Dock Assembly
120V AC/DC Power Supply
Resources Required
• Phillips screwdriver
• Heat gun
• Heat shrink tubing
• Four #8 pan head screws
• Two butt connectors
• Wire crimpers
• Wire strippers
• 18 AWG power and ground
wire (depending on location
of installation related to
power source)
AquaFr
Installation and Owner's Manual
(For Aftermarket Applications)
1. Make sure watercraft is dry-docked or otherwise
supported above water to avoid an unstable condition
created by waves.
2. Locate a mounting area that allows connection of the
AquaFi Hotspot Dock Assembly's power and ground wires
to the watercraft's power source without creating a strain
on the completed connection.
NOTE : The mounting dock should be easily accessible
with enough room to remove the AquaFi Hotspot Assembly
from its dock .
3. If necessary, remove the AquaFi Hotspot (Fig.2A) from its
mounting dock (Fig.2B) and set aside for later use.
A. Slightly lift and hold the top clamping tab.
B. Pivot the hotspot unit forward and release the
clamping tab.
4. Connect the mounting dock's red power (Fig.3A) and
black ground (Fig.3B) electrical wires to the appropriate
wires of the watercraft's power system with crimp-style butt
connectors (Fig . JC) .
NOTE: Mounting dock electrical wires (Fig.3A and B) are
6" long.
lc11.com 574-537-8900 2 CCD-0002558 Rev 05.23.19