Owner's Manual

5
taylormadeproducts.com/wavemaker 574-537-8900 Rev:06.11.20
Taylor Made
®
Wavemaker Stereo
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0003867
Master Volume Control
The master volume can be adjusted from 0 to -59dB (Fig.5).
Equalizer Reset Buttons
• Reset All - Restores default settings (Fig. 6A).
• Reset EQ - Sets the gain to 0 and the Q and Hz to
default (Fig. 6B).
• PEQ Parameter or Graphic Equalizer - In graphic
mode, the Q or Hz cannot be adjusted (Fig. 6C).
• Reset Gain - Will set all 31 gains to 0 (Fig.6D).
Fig.5
Fig.6
A C
B
D
Crossover Configuration
Choose between Butterworth or Bessel filter type (Fig. 8A).
Select the appropriate frequencies (Fig. 8B) and slopes for
each speaker (Fig. 8C).
Fig.7
A
B
C
WHEN USING EXCITERS, IT IS RECOMMENDED THAT
THE HIGH PASS FREQUENCY BE SET TO 80Hz AND
THE SLOPE AT 24dB. ANY OTHER SETTING MAY
RESULT IN DAMAGE TO THE EXCITERS.
Save Modes
• Save DSP - Saves the EQ parameters into the DSP EQ1
through 8. EQ name is limited to 20 characters (Fig.9A).
• Load DSP - Accesses EQ1 through 8 parameters that
are stored in the DSP (Fig. 9B).
• Source - Allows selection between Bluetooth or RCA
Line In (Fig. 9C).
• Save PC - Saves the EQ parameters to the Documents
folder on the PC (Fig. 9D).
• Load PC - Accesses the Documents folder on the PC
and allows previously saved EQ parameters to be
loaded (Fig. 9E).
• Update - Not supported (Fig. 9F)
Fig.8
A D
B
E
C
F
Current Settings
• Save Mode - Indicates which EQ preset is saved in the
DSP (Fig.7).
• Current Mode - Indicates which EQ setting is active (Fig.7).
• Source - Indicates if Aux Line or Bluetooth is in use (Fig.7).
Fig.9