Installation Manual

lippertcomponents.com 574-537-8900 Rev: 02.17 - Jack-It
®
Jack-It
®
Installation and Owner’s Manual
(For Aftermarket Application)
Manual information may be distributed as a complete
document only, unless Lippert Components provides
explicit consent to distribute individual parts.
All manual information is subject to change without
notice. Revised editions will be available for free
download at www.lippertcomponents.com. Manual
information is considered factual until made obsolete by
a revised version.
Please recycle all obsolete materials and contact
Lippert Components with concerns or questions.
Securing Bikes
1. For 2 bicycles, the best technique is to position the
bicycles front to back/back to front with the chain ring to
the outside.
2. Hang 1 bicycle on the trailer side of the bicycle rack
so the top of the wheels are each supported by a cradle
(Fig.7).
3. Secure by tensioning each rubber strap over the top of
each tire and engaging a strap hole with the end of the
cradle.
4. Use 1 SwayStop pin to secure at least 1 wheel below
the frame where the wheel crosses the wing using the
same technique with the stop pin rubber strap. A second
and optional SwayStop pin is provided to secure both
wheels of the bike to the rack if desired.
5. Repeat for a 2nd bicycle on the tow vehicle side of the
bicycle rack.
ALWAYS MAKE SURE ALL CONNECTIONS BETWEEN
THE BICYCLE RACK AND THE TRAILER COUPLER ARE
SECURE/TIGHT/READY FOR TRAVEL. ALWAYS MAKE
SURE THE BICYCLES ARE SECURELY ATTACHED TO
THE BICYCLE RACK BEFORE DRIVING.
4
Fig.7
46 ¾”
60 3/8”
56 3/8”
or
Maximum Weight Capacity
The maximum weight capacity of the Jack-It bicycle rack is
80 pounds.
DO NOT EXCEED THE WEIGHT CAPACITY OR THE
RECEIVER HITCH MANUFACTURER’S TONGUE WEIGHT
RATING. FAILURE TO ACKNOWLEDGE WEIGHT
RATINGS MAY RESULT IN DAMAGE TO THE TRAILER.
29 3/16”
22 ½”
18 ½”
or
or
25 3/16”
Dimensions of Assembled Jack-It (Fig. 7)
Check dimensions to ensure adequate clearances for
tongue jacks and liquid propane (LP) tanks. Critical
measurements for jacks are inside clearances of 22 ½”
and 18 ½” for the standard and manual PowerTowers. The
29 ⁄” and 25 ⁄” measurements from the coupler to the
wing base will determine LP tank clearance.