Installation Manual

lippertcomponents.com 574-537-8900 Rev: 02.17 - Jack-It

Jack-It

Installation and Owner’s Manual

(For Aftermarket Application)

Resources Required

Installation Instructions

1. Remove the tongue jack from the coupler. Position

the PowerTower™ (Fig.1G) on the coupler. Place the

tongue jack on the PowerTower (Fig.1G) and secure

both to the coupler using 3 nuts, bolts and washers each

(Fig.1H, 1I and 1J).

NOTE: If there is no tongue jack, attach the PowerTower

(Fig.1G) to the coupler on the front of the trailer using 3

nuts, bolts and washers each (Fig.1H, 1I and 1J).

NOTE: There are two PowerTower options available. The

standard option has an inside clearance of 22 ½”. The mini

jack, to accommodate manual tongue jacks, has an 18 ½”

inside clearance.

2. Attach the Stinger™ (Fig.1F) to the PowerTower

(Fig.1G) using the NoMotion™ pin and washers

(Fig. 1A, 1C and 1D). For safety, insert the cotter pin

(Fig.1B) through the hole at the end of the NoMotion pin

(Fig.1A) after tightening securely.

NOTE: The NoMotion pins are lockable with a customer-

supplied padlock having a ¼” or smaller hasp.

3. Attach the base (Fig.1E) to Stinger (Fig.1F) using the

NoMotion pin and washers (Fig.1A, 1C and 1D). For

safety, insert the cotter pin (Fig.1B) through the hole at the

end of the NoMotion pin (Fig.1C) after tightening securely.

Fig.1

• ⁄” Socket Wrench

• ¾” Socket Wrench