User Manual

Rev: 09.04.2015
Page 5
Waste Master® Installation Manual
Fig. 8
Cam Lock Arms
Fig. 9
7. Insert the Waste Master® hose end, which has the 3” male cam lock fitting (Fig. 3), into the previously
installed storage box through the opening at the end of the box. From the inside of the box, push the
male cam lock fitting out through the 4” hole in the side.
8. With the cam lock arms in the open position (Fig. 8) insert the male cam lock fitting into the female cam
lock (Fig. 9). Lock the hose in place by pushing the arms down against the side of the female cam lock.
NOTE: Inserting the cam lock cap is required during storage and transportation of the unit if the male cam
lock fitting on the hose is not locked into the female cam lock fitting. To install the cap, start with
the arms on the female cam lock in the open position. Insert the cap and lock it in place by pushing
the arms down against the side of the female cam lock.