User Manual

Rev: 09.04.2015
Page 3
Waste Master® Installation Manual
Installation of System
1. The female cam lock (Fig. 2) affixes to the holding tank outlet pipe.
2. The male cam lock fitting comes pre-installed on the end of the 4:1 compression hose (Fig. 3).
3. The end of the holding tank outlet pipe on the coach MUST be directed at and be within 3" of the hole
in the side of the storage box (Fig. 4).
4. Apply the ABS glue to the pipe at the coach. Apply ABS glue to the female cam lock fitting and apply
another swipe of glue to the pipe at the coach. Take the cam lock fitting and push it on the pipe, turn
approximately 90 degrees to the final position and hold in place for 30 seconds.
NOTE: The waste pipe is ABS pipe. Use approved glue for ABS piping. Do not use glue for PVC or CPVC
piping. Allow 15 minutes for the glue to set before proceeding.
Fig. 2 Fig. 3
Fig. 4
≤3"