User Manual

JT Strong Arm Travel Trailer
Aftermarket
Installation Manual
www.lippertcomponents.com [phone] Rev: 07.25 - JT Strong Arm Travel Trailer Install Manual
5
2. Remove the bolt that holds the
foot pad onto the jack (Fig. 13).
3. Align adapter plates to holes
in foot pad. Place the smaller
half down and on the outside of
brackets (Fig. 14).
4. Loosely attach 4” swing bolt
and adapter plates to foot pad.
Adapter plate holes may need to
be enlarged using either a 3/8” or
25/64” drill bit (Fig. 15).
5. Attach the removed bolt to
the top hole of the adapter plate
through the jack arm (Fig. 16).
Tighten all bolts.
Fig. 12 Fig. 13
Fig. 14
Fig. 15 Fig. 16
Fig. 17
1. Existing foot pad (Fig. 12)
6. Attach JT Strong Arm stabilizer
to the swing bolt and tighten
(Fig. 17).
P/N 314597 - Electric Stabilizer
Jack Pad Adapter kit (4/pkg).
This optional kit is used to attach stabilizers to LCI
Electric Stabilizer Jack foot pads. One plate goes on
each side of the jack pad to allow electric Jack to fully
retract.