User Manual

JT Strong Arm Travel Trailer
Aftermarket
Installation Manual
www.lippertcomponents.com [phone] Rev: 07.25 - JT Strong Arm Travel Trailer Install Manual
2
P/N 191025 - Jack Stabilizer, Travel Trailer
B
C
E
J
K
I
A
D
G
H
F
Callout Description
Qty
A Stabilizer Outer 1 ¼ " O.D. 6
B Stabilizer Inner 1" O.D. 6
C Bolt - ⁄ - 16 x ¾ T-Bolt 6
D
Nut - ⁄ - 16; Nylon Insert Lock
Nut Zinc
30
E
Washer - ⁄; SAE Flat Washer
Zinc
48
F
Bolt - ⁄ - 16 x 1 ½ ; Hex Cap
Screw Gr5 Zinc
18
G Bolt - ⁄-16 X 1-¼ Swing Bolt 6
H Bolt - ⁄-16 X 4 Swing Bolt 6
I 2.750 X 1.250 Sti ening Pad 6
J
Spacer Mount - 4.500 X 1.500 X
1.500
4
K
Bolt - ⁄-16 X 1; Hex Washer
Head Thrd Cutting Slotted Zn
8
Single-Arm “C” Type Telescoping
Jack
Scissor Jack
Installation
1. Determine what style of jacks are on the chassis by comparing the
pictures with the rear jacks (Fig. 1, Fig. 2, and Fig. 3).
If the chassis has electric stabilizer jacks, refer to page 5.
If the chassis has hydraulic stabilizer jacks, refer to page 6.
NOTE: For 2006 or later telescoping jacks, replace existing ⅜ ”
jack pad bolt with ⅜ -16 X 4 swing-bolt. Use ⅜ ”-16 nut (P/N
191019) to secure. Insert a ⅜ ” x 1 1/4” swing-bolt with the tab
pointing to the rear of the chassis. Secure with a ⅜ ” washer
and ⅜ ” locking nut. Tighten as described in Step 11. Prepare
“T” bolts and stabilizer tubes as described in Step 8, except
the inner tube should be set at 1” instead of 5”. After fully
retracting rear telescoping jacks, attach the clevis end of the
stabilizer inner tube to the swing-bolt tab on the rear side of
the jack using a ⅜ ”-16 x 1 ½” bolt with a ⅜ ” washer on the top
and bottom of the tab and a ⅜ ” locking nut. Tighten nut until
tight. Repeat this step on the opposite side.
Fig. 1
Fig. 2
2. Locate a cross-member rearward of the rear jacks at a minimum of 4”
to a maximum of 18” for jacks mounted at an angle. For jacks mounted
square with the chassis frame, use a minimum of 6”.
3. Under front half of chassis, locate a cross-member or center compart-
ment with a steel  oor from 6”-18” from front of front jacks. If unable
to locate a suitable mounting location at either front or rear of chassis,
please call Customer Service toll free at 1-574-537-8900 8 AM to 5 PM
EST.
Rear Electric Stabilizer Jack
Fig. 3