User Manual

‑ 10 ‑EN
the wall with the use of screws or adhesive tape (g. 2).
How to install with screws
1.
Mark the spot on the wall in which you wish to drill holes for
rawlplugs (g. 3).
2. Make a hole with a tool suitable for the specic surface and then
put rawlplugs in (g. 4).
3. Fix the assembly bracket by screwing screws in (g. 5).
4.
Place the camera on the wall and posion for the best angle of view.
Troubleshoong
Problem/queson Possible soluon
The camera is not visible
in the applicaon.
Check Wi-Fi signal strength or place
the camera near the router while
conguring. Reset the camera and
add it again.
The camera is still in
the list of devices in the
applicaon aer reseng.
Reseng changes camera sengs
only. The camera must also be deleted
in the applicaon.
How to change Wi-Fi
network which the camera
is connected to?
Delete the camera from the list of
devices in the applicaon, and then
congure it again by connecng to
other network.
The camera cannot
idenfy microSD card.
It is advisable to insert microSD card
when the camera is o. Make sure the
card is available and comes in FAT32
format and its maximum capacity is
128 GB. Check Internet connecon.