Owner's Manual

FCC and RSS Statements
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Model Numbers:
Berkshire: 7-12100
General: 7-12102
4-6-0: 7-12103
Remote: 7-12105
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device
may not cause interference, and (2) This device must accept any interference, including interference that may cause
undesired operation of the device.
• Always purchase the correct size and
grade of battery most suitable for the
intended use.
• Always replace the whole set of batteries
at one time, taking care not to mix old and
new ones, or batteries of different types.
• Clean the battery contacts and also those
of the device prior to battery installation.
• Ensure the batteries are installed correctly
with regard to polarity (+ and -).
• Remove batteries from product during
periods of non-use. Battery leakage can
cause corrosion and damage to this
product.
• Remove used batteries promptly.
• For recycling and disposal of batteries,
and to protect the environment, please
check the internet or your local phone
directory for local recycling centers and/
or follow local government regulations.