User's Manual Part 2
38
Speakerphone Operation
This telephone allows you to answer calls using the BASE UNIT through the speakerphone
function.
1. When the phone rings, press the button. The BASE UNIT LED MESSAGE
DISPLAY will show “SP.”
2. Start your conversation.
3. To end your conversation, press the button again
NOTE: Press the or button to adjust the BASE UNIT speaker volume to your
comfortable listening level.
Security System
Your cordless telephone uses a digital coding security system to prevent unauthorized use of
your telephone line by another nearby cordless telephone. The system has its own identifying
signal created by microcomputers in both the BASE UNIT and the HANDSET.
Security Code
This telephone has an internal security code with 4,000,000 possible combinations.
Resetting Security Code and Channel Information
Communication between the HANDSET and the BASE UNIT may not be possible in any of the
following situations:
1. After a power failure.
2. After relocating the BASE UNIT by disconnecting the AC ADAPTOR.
3. After replacing the HANDSET BATTERY PACK.
77 Channel Auto-Hop
Your cordless telephone automatically selects the best channel from the 77 frequencies
available to transmit signals between the BASE UNIT and the HANDSET. When an interference
is received from other cordless telephones, your telephone automatically hops to the next clear
channel.
SPEAKER
SPEAKER
VOL+ VOL-
M
1
V
O
L
+
V
O
L
-
P
A
G
E
S
T
O
P
S
P
K
P
L
A
Y
M
2
M
3
M
4
Speakerphone Operation
Using the Remote Instruction Code
1. Dial your telephone number.
2. Listen to or bypass the OGM in the PRIMARY MAILBOX.
3. Enter your Remote Access Code. If the announcement does not stop, enter the Remote
Access Code again.
4. The Answering System will request that you enter the Instruction Code or press the “*”
button for help.
A. If you do not know the Instruction Code, press the “*” button immediately. The Answering
System will announce the Instruction Codes. Otherwise, if a command is not received by
the Answering System within 10 seconds, it will automatically hang up.
The following is the Remote Instruction Code Help Menu:
Instruction Codes
To playback message press “2.”
To repeat message press “1.”
To skip message press “3.”
To stop press “8.”
To playback announcement press “5.”
To turn answering machine ON or OFF press “6.”
To erase message press “9.”
To Record memo or announcement press “0.”
(To record a message press “2”, to record announcement press “5”)
(Press “1” for MAILBOX 1, press “2” for MAILBOX 2, press “3” for MAILBOX 3, and
press “4” for MAILBOX 4. Otherwise, if you did not press the desired MAILBOX #
location within 2~3 seconds, the Answering System will automatically hang up.)
To change mailbox press “#.”
B. Press the corresponding number of the Instruction Code you wish to activate. You don’t
have to listen to the entire Instruction Code Help Menu before giving a command. You
may enter the desired Instruction Code Number at any given time.
37
DSST~2801~B.qxd 1/25/2003 7:04 PM Page 28