User's Manual Part 1

1. Button: Press and hold down to record memo messages.
2. Button: Press to set/check the day and time.
3. (OUTGOING MESSAGE) Button: Press and hold down to record OGM messages.
4. Button: Press to erase messages.
5. CHARGE TERMINALS: For charging the HANDSET BATTERY PACK. For best
performance, clean the CHARGE TERMINALS periodically with a damp cloth.
6. SPEAKERPHONE LED Indicator: Lights up when the BASE UNIT speakerphone function
is activated.
7. IN USE/CHARGE LED Indicator: (IN USE) Lights up to indicate that the HANDSET is in
TALK mode. (CHARGE) Lights up when the HANDSET is placed on the BASE UNIT for
charging.
8. ANSWER FUNCTION ON/OFF (ANS. ON/OFF) LED Indicator: Lights when the answer
function is turned ON.
9. MICROPHONE
10. (ANSWER FUNCTION ON/OFF) Button: Press to activate or deactivate the answer
function.
11. Button: Press to PAGE the HANDSET. Press again to stop.
12. Button: Press and hold to set the 3-digit Remote Access Code for remote operation.
13. MESSAGE ALERT: Set switch to ON to generate a “beep” sound every 12 seconds when a
new message has been received.
14. ANNOUNCE ONLY/INCOMING MESSAGE Switch:
ICM - System records the incoming messages.
ANNC - System plays your announcement and then hangs up without recording messages.
15. RINGER ON/OFF Switch: Set switch to OFF position to disengage the ringer on the BASE
UNIT.
16. RING SELECT Switch: To select the number of rings before the Answering System answers
a call.
3R - System answers a call after the third ring.
5R - System answers a call after the fifth ring.
TS (TOLL SAVER) - System answers after the third ring only if you have new
messages. Otherwise, the system will answer after the fifth ring.
17. (MAILBOX 1) Button: Press to activate functions for MAILBOX 1.
MEMO
BASE UNIT Controls BASE UNIT Controls
18. (MAILBOX 2) Button: Press to activate functions for MAILBOX 2.
19. (MAILBOX 3) Button: Press to activate functions for MAILBOX 3.
20. (MAILBOX 4) Button: Press to activate functions for MAILBOX 4.
21. BASE UNIT ANTENNA
22. MAILBOX LED Indicators: Lights to indicate the presence of message(s) and blinks to
indicate that the corresponding MAILBOX is active and ready to operate.
23. Button: Press to stop playing a message.
24. (VOLUME UP) Button: Press repeatedly to increase the speaker volume level of the
BASE UNIT.
25. (VOLUME DOWN) Button: Press repeatedly to decrease the speaker volume level of
the BASE UNIT.
26. Button: Press to play messages.
27. Button: Press to skip messages.
28. LED MESSAGE DISPLAY: Indicates the number of memos/messages received, status of the
system.
EA - Erasing 01~63 - No. of memos/messages OP - OGM is playing
Ao - Announce Only FU - Memory is full PA - Pause
SP - Speakerphone function is being used
29. Button: Press to repeat messages.
30. (SPEAKERPHONE) Button: Press to answer a call using the BASE UNIT.
31. TONE-PULSE SELECT SWITCH
32. RESET Button: Press and hold down for 2 seconds to reset the system and clear all
recordings.
33. POWER-IN CONNECTION JACK
34. TELEPHONE LINE CONNECTION JACK
TIME
OGM
ERASE
ANS
ON/OFF
PAGE
CODE
MAIL
1
MAIL
1
MAIL
3
MAIL
4
STOP
VOL+
VOL-
PLAY
SKIP
RPT
SPK
DSST~2801~A.qxd 1/25/2003 6:46 PM Page 8