User's Manual

BASE UNIT Controls
1. (MAILBOX 1) Button: Press to activate functions for MAILBOX 1.
2. (MAILBOX 2) Button: Press to activate functions for MAILBOX 2.
3. (MAILBOX 3) Button: Press to activate functions for MAILBOX 3.
4. (MAILBOX 4) Button: Press to activate functions for MAILBOX
5. MAILBOX LED Indicators: Lights to indicate the presence of message(s) and
blinks to indicate that the corresponding MAILBOX is active and ready to operate.
6. Button: Press to repeat messages.
7. Button: Press to set/check the day and time.
8. (VOLUME UP) Button: Press repeatedly to increase the speaker volume level
of the BASE UNIT.
9. (VOLUME DOWN) Button: Press repeatedly to decrease the speaker volume
level of the BASE UNIT.
10. Button: Press to PAGE the HANDSET. Press again to stop.
11. CHARGE TERMINALS: For charging the HANDSET BATTERY PACK. For best
performance, clean the CHARGE TERMINALS periodically with a damp cloth.
12. Button: Press and hold down to set the 3- digit Remote Access Code for
remote operation.
13.TONE-PULSE SELECT SWITCH
14.MESSAGE ALERT: Set switch to ON to generate a “beep” sound every 12 seconds
when a new message has been received.
15.ANNOUNCE ONLY/INCOMING MESSAGE Switch:
ICM - System records the incoming messages.
ANNC - System plays your announcement and then hangs up without
recording messages.
16.RINGER ON/OFF Switch: Set switch to OFF position to disengage the ringer on the
BASE UNIT.
17.RING SELECT Switch: To select the number of rings before the Answering System
answers a call.
3R - System answers a call after the third ring.
5R - System answers a call after the fifth ring.
TS (TOLL SAVER) - System answers after the third ring only if you have new
messages. Otherwise, the system will answer after the fifth ring.
18.BASE UNIT ANTENNA
19.LED MESSAGE DISPLAY: Indicates the number of memos/messages received,
status of the system.
EA - Erasing 01 ~63 - No. of memos/messages OP - OGM is playing
Ao - Announce Only FU - Memory is full PA - Pause
RPT
TIME
VOL +
VOL -
PAGE
CODE