User's Manual

When the Memory is Full

When there is no memory available for additional messages, the answering system will announce,

“memory full,” but will not save messages.

Remote Access Codes

The remote access code preset at the factory as shown below. You can use the preset code or

choose your own.

PRIMARY MAILBOX : 999

Changing of the Remote Access Codes

1. Press and hold down the button until you hear the announcement.

2. Press the or to select the first digit, then press the button to accept the

setting.

3. Press the or to select the second digit, then press the button to accept

the setting.

4. Press the or to select the third digit, then press the button to accept

the setting, the answering system will automatically announce your new pasword.

Using the Remote Instruction Code

1. Dial your telephone number.

2. Listen to or bypass the OGM in the primary mailbox.

3. Enter your Remote Access Code. If the announcement does not stop, enter the Remote

Access Code again.

4. The answering system will request that you enter the Instruction Code or press the “0”

button for help.

A. If you do not know the Instruction Code, press the “0” button immediately. The answering

system will announce the Instruction Codes. Otherwise, if a command is not received by

the answering system within 10 seconds, it will automatically hang up.

Answering System Operation

SKIP

REPEAT

CODE

SKIP

REPEAT

CODE

Man PM3375.qxd 2/25/2004 11:26 AM Page 36