User's Manual

A
IMPORTANT: To ensure the proper operation of your Answering System:
1. Plug the AC Adaptor into the Power - In Connection Jack.
2. Press and hold down the RESET button for 2 seconds at the back of the Base Unit
before initial use.
Setting the Day and Time
1. Day Setting
Press and hold down the button for 2
seconds then press the or button
to select the desired day setting. Press the
button again to accept the setting,
and then the LED Screen will display the hour
setting.
2. Hour Setting
Press the or button to select the
hour, then press the button to accept
the setting. The LED Screen will display the
minute setting.
3. Minute Setting
Press the or button to select the
desired minute, then press the button
to accept the setting.
NOTES:
1. The Handset and Base Unit clocks are independent from each other. Set the Handset
clock by following the time setting steps on page 17.
2. In case of power failure, reset the time setting on the Base Unit clock.
Recording Your Outgoing Messages
Your answering system provides one Primary mailbox which can receive their own incoming
messages (ICM). Before using your answering system, it is suggested that you record an
outgoing Message (OGM). This is the announcement callers will hear when the system answers a
call.
A prerecorded system announcement “Please record your message after the beep” is available
if you choose not to record your own OGM.
SKIP
31
Answering System Operation
TIME
REPEAT
TIME
SKIP
REPEAT
TIME
SKIP
REPEAT
TIME
PL AY
VOL-
VOL+ STOP
ERASE
TIME ON/OFF CODE PAGE
ANSWER
ANSWER
ON/O FF
IN USE
CHARGE
OGM MEMOSPEA KER
REPEAT SKIP
Digital
Answering
Machine
2.4GHz DSST
Skip button
Repeat button
Time button
Man PM3375.qxd 2/25/2004 11:26 AM Page 32