User's Manual

1. When the phone rings, the LCD Screen of all of the

Handsets registered to the system will display “Ring.” If

you have Caller ID, the LCD Screen will display the

Caller ID information after the first ring.

2. With the Handset on or off of the Base Unit, press the

button. “Talk” will be displayed and the Call Timer

starts to count. Start your conversation.

3. To end your conversation, either press the button

or place the Handset on the Base Unit. The duration of

the call will be displayed on the LCD Screen for about 3

seconds and then returns the LCD Screen to the

standby mode.

Receiving Calls

When a call is received, all of the Handset registered to the system will ring with the ringer level

and melody selected by the user. The first Handset to respond will get the call.

NOTE: If you are too far away from the Base Unit, the Handset emits “beep” sounds to warn

you that the background noise level is too high for proper communication between the

Handset and the Base Unit. When you hear this sound, you should move closer to the

Base Unit to reduce the noise level. Otherwise, the call will automatically cut off.

Basic Operation

TALK

Extension In Use Indicator

This telephone can detect when a Handset is already in

use. The LCD Screen of all of the Handsets currently

linked to the same Base Unit will display “Ext in-use.”

This means you will have to wait until the line is free to

make a call.

1, 2

Redial Feature

1. If you get a busy tone, press the button or

place the Handset on the Base Unit to hang up.

2. Later, press the button again.

3. Listen for a dial tone and then press /RE/

PA to redial the number last dialed.

TALK

SAVE

Man PM3375.qxd 2/25/2004 11:26 AM Page 15