User's Manual

11
Desk Mounting
For normal position, as shown in figure 1, place
the Base Unit on any desired but suitable location.
Normal Position (Mounting Bracket not required).
Telephone Setup
Wall Mounting Instructions
1. Connect the short telephone line cord to the
Telephone Line Connection Jack on the back
of the Base Unit.
2. Insert the free end of the short line cord through
the hole of the mounting bracket.
3. Insert the hooks of the mounting bracket into
the matching slots on the back of the unit.
Press the two locks located on the side of the
mounting bracket until the locking hooks snap
into the inner slots of the Base Unit.
4. Press the middle locking hooks of the mounting
bracket while pushing the back of the mounting
bracket until it snaps to lock.
5. Plug the free end of the short line cord into the
modular wall jack.
Modular Wall Jack
Wall Plate Stud
Wall Plate
5
6. Align the upper keyhole on the mounting bracket with the upper stud of the wall plate, so that
the opening end of the mounting bracket matches the lower stud, pull the mounting bracket
down until it is securely seated.
Man PM3375.qxd 2/25/2004 11:26 AM Page 12