User's Manual

ManualsBrandsLionda Technology ManualsElectronics2.4GHz Digital Spread-Spectrum Cordless Phone

Telephone Setup

Connecting the Phone

This section is a reference guide to the basic functions and operations of your cordless telephone.

For more detailed descriptions of the operations and features of this telephone, refer to the

Contents on page 1.

1. Carefully remove your cordless telephone from its shipping carton. If there is any visible

damage, do not attempt to operate this equipment. Return it to the place of purchase.

2. Insert the small plug on the end of the AC Adaptor into the Power-In Connection Jack at the

back of the Base Unit.

3. Plug the AC Adaptor into a 120V AC wall outlet.

USE ONLY WITH CLASS 2 POWER SOURCE:

9V DC, 500mA for the BASE UNIT.

9V DC, 150mA for the CHARGER UNIT.

4. Insert one plug of the Telephone Line Cord into the house Telephone Jack and the other end

into the Telephone Line Connection Jack at the back of the Base Unit. (If you have an older

4-prong Telephone Jack, you will need an RJ-11C Telephone Jack Adaptor. This adaptor is

available at the same place you purchased your telephone.)

5. We recommend not placing this unit next to appliances. Doing so may cause interference.

Tone/Pulse Select Switch

A. If your home is equipped with a tone dialing system, set the TONE/PULSE Select Switch to

the TONE position.

B. If you have a rotary dialing system, set the TONE/PULSE Select Switch to the PULSE

position.

C. If you are not sure which system you have, set the TONE/PULSE Select Switch to the

TONE position. Press the button on the Handset to get a dial tone, and press any

button on the telephone keypad except the zero. If the dial tone continues, it means that you

do not have TONE dialing service. Press the button on the Handset to hang up. Set

the TONE/PULSE Select Switch to the PULSE mode and then try again.

TALK

Telephone Line

Connection

Jack

Power-in Connection

Jack

Telephone Line Cord

120V Wall

outlet

AC Adaptor

Telephone

Jack

Connecting the Base

USE ONLY WITH CLASS 2 POWER SOU RCE

TEL L INE

ON OFF

TS 5R 3R

RING SE LECT

IC M ANNC

SELECT

TONE/PULSE

RINGER

Man PM3375.qxd 2/25/2004 11:26 AM Page 11