User's Manual

Multi-Handset, Multi-Base Unit System Operation

The system supports the registration of 9 Handsets to a Base Unit. The user can add another

Base Unit (B2) and register the same Handsets. The Base Units must be connected to separate

telephone lines. The Handsets can make Intercom Calls, and Call Transfers to one another

provided they are using the same Base Unit at that time.

Intercom Call

1. With the Handset in standby mode, press the /INT

button . The LCD Screen of the initiating Handset will

display “Select H/S:.”

2. Enter the ID # of the receiving Handset by pressing the

keypad to buttons.

3. The receiving Handset will receive a page tone and the

LCD Screen will display “Handset #, Paging you.”

4. The receiving Handset will connect by pressing the

/INT button. Both LCD Screens will display “Intercom

with:, Handset #.”

5. To end the Intercom Call, press the /INT button again.

The LCD Screen of both Handsets will return to standby

mode.

Receiving a Call while in Intercom Call

1. When an outside call is received, both Handsets

involved in the Intercom call will emit two short double

“beep” sounds. The Caller ID information, if available,

will display on the LCD Screens after the alert beeps.

2. Press the /INT button to terminate the Intercom

call.

3. Press the button to access the outside call.

TALK

DEL

WXYZ

Man PM3320.qxd 2/25/2004 11:20 AM Page 29