User's Manual

Press the button to confirm that you have a

dial tone. If you still do not have a dial tone, refer

to the trouble shooting on page 32.

Belt Clip Installation

With the back of the Handset facing up, insert one side

of the belt clip hook into the matching slot at the top side

of the Handset. Press down on the opposite side of the

belt clip until the other hook locks into the slot on the

side of the Handset.

Telephone Setup

Battery Installation

1. Install the Handset Battery Pack by plugging it into

the Battery connector inside the Battery

compartment. Place the Battery Pack inside the

Battery Compartment.

2. Slide the Handset Battery compartment cover

firmly into place in its closed position

3. Once you have installed the Battery Pack and

placed the Handset on the cradle you will hear a

tone indicating the Handset has connected with the

charging contacts and will successfully charge.

4. IMPORTANT: Before initial use, charge the

Handset for 12 hours.

Battery Duration

A fully charged battery lasts for approximately:

4 hours when you use the Handset continuously (talk time).

5 days when the Handset is not is use (standby).

Using the Headset Feature

The headset jack is located on the side of the Handset

and is a standard 2.5mm plug. Simply plug the head-

set (not included) into the jack and headset will be

active.

NOTE: When you plug the headset plug into the

Headset Jack it automatically mutes the Microphone

and Speaker of the Handset. Unplug the headset to

return the Handset to normal use.

TALK

Man PM3320.qxd 2/25/2004 11:20 AM Page 12