User's Manual

10
Telephone Setup
Desk Mounting
For normal position, as shown in Figure 1, place
the Base Unit on any desired but suitable location.
Normal Position (Mounting Bracket not required).
Wall Mounting Instructions
1. Connect the short telephone line cord to the
Telephone Line Connection Jack on the back
of the Base Unit.
2. Insert the free end of the short line cord through
the hole of the mounting bracket.
3. Insert the hooks of the mounting bracket into
the matching slots on the back of the unit.
Press the two locks located on the side of the
mounting bracket until the locking hooks snap
into the inner slots of the Base Unit.
4. Press the middle locking hooks of the mounting
bracket while pushing the back of the mounting
bracket until it snaps to lock.
5. Plug the free end of the short line cord into the
modular wall jack.
6. Align the upper keyhole on the mounting
bracket with the upper stud of the wall plate, so
that the opening end of the mounting bracket
matches the lower stud, pull the mounting
bracket down until it is securely seated.
VOL
TAL K
DIR/
ESC
13
2
0
#
*
FLASH
EDITSAVE
RE/PAMENU
DEL
INT
ABC DEF
6
MNO
5
JKL
4
8
TUV
GHI
7
PQRS
9
WXYZ
OPERTONE
2.4GHz DSST
PAGE
IN USE CHA RGE
Modular Wall Jack
Wall Plate Stud
Wall Plate
5
Man PM3320.qxd 2/25/2004 11:20 AM Page 11