@ BELL SOUTH CORDLESS TELEPHONE 2.4 GHz DIST FILTERED SCUND™ WITH 70 CHANNEL AUTO SCAN 2.4 GHz DIGITAL SPREAD SPECTRUM OWNER'S MANUAL INSTALLATION AND OPERATING INSTRUCTIONS PLEASE READ THIS MANUAL CAREFULLY BEFORE USE. KEEP FOR YOUR REFERENCE, For installation information, please see "Getting Started” instructions an page 4 or your separate Quick Start guide.
7 | BASICDSSTL,065 1 Special Features congratulations on your selection of a quality Bell South Product. With proper care, and by following the setup and user instructions in this unreal, this unit will provide you with years of trouble free service. Elisabeth is committed to providing quality products that fit your needs. We would fiche to have ahy comments or suggestions you might have on this product. You may mail your comments to U.S.
HANDSET Controls A. HANDSET ANTENNA: ~~ 2. REAP BUTTON =. 7. HANDSET VOLUME. Pg. 10-11 { CONTROL (HI, MID, LOW) SWITCH 8, IN BATHHOUSE LOW LED INDICATOR Pg. 8,913 3. TALK BUTTON pawl) g 7 + §, FLASH BUTTON N "— 10. HEADSET JACK Py 1H Th PHONE BUT ION 12. RINGER DOFF SWITCH Pg. 9 6. CHARGE CONTACTS For installation information, please see “Getting Started” instructions on page 4 or your separate Quick Start guide.
I HANDSET ANTENNA REDIAL PAUSE PAIGE) Button : (REDIAL) Press to remediate last number ’ dialed. (PAUSE) Press to insert a pause while dialing {You will ned the button to dial numbers which use an alternative Long Distance Aces } TALK Button: Press (0 answer an incoming call of (0 place a call. Press to end a call: MUTE GRID Button: Press to disable the microphone. Allows you to hear your caller.
BASE UNIT Controls 1. TELEPHONE LINE © 2 POWER 3{ TONE/PULSE CONNECTION JACK CONNECTION JACK SELECT SWITCH Pg 4.5715 Pg Pg.5, 16 4. PAGE BUTTON ~ 5 ANTENNA 15,16 8. iN SURCHARGE LED INDICATOR P10 7.
BASE UNIT Controls TELEPHONE LINE CONNECTION JACK POWER CONNECTION JACK . TONE PULSE Select Switch PAGE (RHE) Button: Press lo page the HANDSET. Press again to stop. ANTENNA: Raise or reposition for the best reception, IN USE/CHARGE LED Indicator: Lights up when the HANDSET is in TALK mode or whee the HANDSET is placed on the BASE UNIT for charging. CHARGE TERMINALS: For charging the BATTERY PACK inside the HANDSET.
Ra Safety Instructions Ek IMPORTANT SAFETY INSTRUCTIONS To reduce the risk of fire, electric shock and/or injury, always follow these basic safety precautions when using your, cordless telephone equipment. 1. Read and understand ali instructions. 2. Follow all wakings and instructions marked on the telephone. Do not se this telephone near a bathtub, wash bow, Kitchen sink, or laundry tub, in 3 a wet basement, nar a swimming pool, or anywhere else where there is water. 4.
Safety Instructions E. If the telephone has been dropped or the case has been damaged. If the telephone exhibits a distinct change in performance. Never install telephone wiring during a lightning storm, Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations. Never touch um insulated telephone wires of terminals unless the telephone hing has been disconnected af the network interface. Usa caution when installing or modifying telephone fines.
=e A EYP Getting Started Connecting Your Phone This section'is a reference guide to the basic functions and operations of your cordless telephone. For more detailed descriptions of the operations and features of this telephone, refer to the Contents on page 1. 4. Garishly remove your cordless telephone from its shipping carton. if thees is any visible damage, do not attempt to operate this equipment. Return it to the place of purchase. 2.
Getting Started 120V WALL OUTLET POWERING i CONNECTION Te ma JACK ADAPTER TONE PULSE SELECT SWITCH TELEPHONE LINE CONNECTION JACK . Install the HANDSET BATTERY PACK by plugging it into the BATTERY CONNECTOR inside the BATTERY COMPARTMENT. Place the BATTERY, PACK inside the BAT TREY COMPARTMENT. . Slide the: HANDSET BATTERY COMPARTMENT COVER firmly inch place in its closed position. IMPORTANT: Before Initial use, charge the HANDSET for 12 hours. ao] BATTERY BACK | TONE/PULSE Select Switch: A.
ANTENNA Press the TALK {#8 button to confirm that you have a dial phone. If you do not get a dial tone, review steps S through 12. If you still du not have a dial phone, refer to the Problem Solving section With tieback of the HANDSET facing up, insert oie side of the BELT CLIP HOOK liftoff the matching slot at the top side of the HANDSET. Press down on the opposite side of the BELT CLIP unit the other hook locks into the soot on the side of the HANDSET.
1 Desk Mounting One of the special features of your telephone is the unique design of the MOUNTING BRACKET which can hold your phone at an angle of 30° when desist moistening. There are two positions to choose from: 1. NORMAL POSITION (MOUNTING BRACKET not required): For normal position, as shown in Figure 1, place the BASE UNIT on any desired but suitable ovation. 30° POSITION (See Figure 2): With the back of the BASE UNIT facing up, tender the hooks of the MOUNTING.
Basic Operation Preparing for Use Before you can use your cordless telephone, you must charge the HANDSET for 12 hours. Failure to da so will require recharging of the BATTERY. PACK more often, 1. Place the HANDSET on the BASE UNIT for 12 hours. 2. After 12 hours, remove the HANDSET from the BASE UNIT, 3. Raise or reposition the BASE UNIT ANTENNA for the best reception.
Basic Operation Receiving Calls with the HANDSET on the BASE UNIT 1. When the phone rings, iii the HANDSET. The IN USE LED indicator will light up. NOTE: The HANDSET RINGER ON/OFF switch must be in the "ON" position for ringer ta operate. . Start your conversation. To end your conversation, either press the TALK GP button or place the HANDSET on the BASE UNIT, If you place the HANDSET on the BASE UNIT CHARGE CRADLE, you activate the automatic STANDBY feature.
Basic Operation Storing Numbers 1. Be sure the BASE UNIT IN USE LED indicator is off and: the HANDSET is in STANDBY mode (See Special Features Section). Press the (SIRE) button. 3. Dial the number you want to store. 4. Prose the (RENE) button again. | Dial the TELEPHONE KEYPAD (80) « button where you want to store that number: You will hear one confirmation Repeat steps 1 through 5 20 store other telephone numbers. EXAMPLE : To store the number 115-1968 under the TELEPHONE KEYPAD button: prostheses . 4.
Basic Operation Redial Feature 1.0 )f you: get a busy tone, press the TALK button to hang up. 2. Later, press the TALK {#8 button again. Listen for a dial tone. 4. ‘Press the (BRIBED button. This wit automatically redial the last telephone number you Called. Using the Headset Feature Your telephone can utilize a headset {not included) to be connected to your HANDSET for you to enjoy hands-free communication; Insert the small plug at the end of the MICROPHONE headset inch the HEADSET.
RLEl1141: Security System Your cordless telephoner uses a digital coding security system to prevent unauthorized use of your telephone line by another nearby cordless telephone. The system has its own identifying signal created by microcomputers in both the BASE UNIT: and the HANDSET. Security Code This telephone has an internal security code with 65,536 possible combinations.
Recharging the BATTERY PACK Battery Type Use the following type and size of BATTERY PACK; Cordless Telephone BATTERY PACK & 3.6V, 800 mAh U.S. Electronics inc. Ni-Cd BATTERY PACK: Mode! BEE NE Gd This BATTERY FRACK is available through: U.S. Electronics Service Center 106 Madison Avenue New York, NY 10018 NOTE: During a power interruption, the BASE UNIT does not operate, and a phone conversation cannot be made on the HANDSET.
Changing the BATTERY PACK Changing the BATTERY PACK The BATTERY PACK provides power for the HANDSET of your cordless telephone, To Replace the BATTERY PACK: 1. Remove the HANDSET BATTERY COMPARTMENT COVER by sliding it down, 2. Pullout the BATTERY PACK PLUG and remove the BATTERY PACK. 3. Pius the new BATTERY PACK into the BATTERY. CONNECTOR, 4. Slide the HANDSET BATTERY COMPARTMENT COVER firmly into place in its closed position. Before use, charge the new BATTERY. PACK for 12 hours.
Problem Solving Problem Solving Section Far your assistance, we have listed below a few dominance problems. Phone does not work, check the following: 1. BASE UNIT is plugged into a power source. 2.0 HANDSET is charged, 3. TONE/PULSE Select Switch is in the right position. 4.. TELEPHONE LINE CORD is plugged into the TELEPHONE JACK. Range of phone limited, check the following: 1.. ANTENNA an the BASE BIT is raised. 2.. BASE UNIT is centrally located in your residence. 3.
Technical Information Technical Information This cordless elephantine uses radio frequencies to allow mobility. There ate certain difficulties in using radio frequencies with a cortices telephone. While these are normal, tha following count affect the operation of your System. Noise Electrical pulse noise is present in most homes at one time ar another. This incise is most intense during electrical storms.
FCC Requirements Federal Communications Commission Requirements This equipment complies with Part 68 of the FCC Rules. A labyrinthine BASE UNIT of this ‘equipment contains, among other information, the FCC Registration Number and the Ringer Equivalence Number (REN; for this equipment. You must; upon fewest, provide this: information to your telephone company. The REN s also useful in determining the quantity of devices that you may connect to your.
J Jes Requirements Federal Communications Commission Requirements (continued) NOTE: This equipment has been tested and fol ind to comply with the lints for a class 8 digital device, pursuant to Part 15 of the FCC Rules.
Warranty Warranty Information Bell South Products One-Year Limited Warranty This limited warranty chefs forth all Bell South Products responsibilities regarding your product. There ars rio other expressed or implied warranties from Bell South Products. Warranty Service Provided If you purchased the telephone new farm a retail vendor, Bell South Products warrants ihe telephone against defects in material and workmanship for a period of one (1) year from the original date of purchase.
: Warranty What to Do for Warranty Service Dusting the first thirty (30) days, a defective product is eligible for over-the-counter exchange a the retailer from whom it was purchased, After thirty (30) days, ihe defective product soul be returned to the authorized service center. Please allow 2-3 weeks for the return of your telephone product. The shipping address of the authorized service center is: U.S. Electronics CONSUMER CENTER C/O Sauternes Bonded Warehouse 4491 ME Zion Ret.
EUR TT FETE This page serves as a template for attar enrichment of screws to the wall when mounting this telephone on the wall, 1. Cut outhits page. 2... Use this template to. determine the distance between screws when mounting this phone on the wall. The two cross hairs identify where to attach the screws.
IMPORTANT In order to get maximum life from the RUTS 3 BATTERY PACK, be sure to cha gu] HANDSET for 12 hours before ini TTY Algeria ig g your BASE UNIT near appliances such us televisions, refrigerators, radios, or microwave ovens may cause interference. IMPORTANT When you hear interference, fel button to change the operating channel, The AC ADAPTER must always be plugged LITTERATEURS pate IMPORTANT To obtain the best reception, be Sure to raise or reposition the BASE UNIT ANTENNA.
Make certain you receive the best performance from your telephone.