User's Manual Part 2

K. Registering the HANDSET

1. Press the /MENU button to enter the menu.

2. Press the button to go to the REGISTER programming option.

3. Press the button. The LCD Screen will prompt

“Select base.” The default setting is “BASE 1 (B1)”.

4. To confirm, press the button again. The LCD

Screen will display “Put down H/S”. Put the HAND-

SET on the BASE UNIT charge cradle within 6

seconds. A confirmation “beep” tone will be heard.

5. The BASE UNIT will automatically assign the ID

number of the newly registered HANDSET. The

HANDSET ID # will be displayed on the LCD Screen.

6. To register more HANDSETS, follow steps 1 to 4.

7. Continue with programming or press the /MENU

button to return to STANDBY mode.

NOTE:

To register the HANDSET/S to another BASE UNIT. Select the BASE 2 option by pressing

the SCROLL UP or DOWN button. The second BASE UNIT (B2) must be

connected to a separate telephone line.

L. Setting the ALARM CLOCK

1. Press the /MENU button to enter the menu.

2. Press the /OPTION button to go to the ALARM CLOCK programming option.

3. Press the button. Set the time by pressing the TELEPHONE KEYPAD to

buttons. Press the button to enter AM, or button to enter PM. The default

ALARM CLOCK setting is “Off.”

4. When the desired setting is displayed, press and hold the /RE/PA button to save

the setting. A long “beep” will sound to confirm the setting has been saved.

5. Press the /MENU button to return to STANDBY mode.

NOTE:

To stop the alarm, press any TELEPHONE KEYPAD button. The ALARM setting is one short

setting and once activated it has to be re-set for the next alarm.

SAVE

Caller ID System Operation

VOL

FLASH/EDIT

VOL

FLASH/EDIT

VOL

FLASH/EDIT

manual 9742.qxd 1/11/2003 11:25 AM Page 35