User's Manual Part 1

9. Slide the HANDSET BATTERY COMPART-

MENT COVER firmly into place in its closed

position.

10. IMPORTANT: Before initial use, charge the

HANDSET for 12 hours.

11. TONE/PULSE Select Switch:

A. If your home is equipped with a tone

dialing system, set the TONE/PULSE

Select Switch to the TONE position.

B. If you have a rotary dialing system, set the

TONE/PULSE Select Switch to the

PULSE position.

C. If you are not sure which system you

have, set the TONE/PULSE Select Switch

to the TONE position. Press the

button on the HANDSET to get a dial

tone, and press any button on the

TELEPHONE KEYPAD except the zero. If

the dial tone continues, it means that you

do not have TONE dialing service. Press

the button on the HANDSET to hang

up. Set the TONE/PULSE Select Switch

TALK

Switch to the PULSE mode and then try again.

12. Set the date and time on the HANDSET. (See page 23 for details.)

13. Set the date and time on the BASE UNIT. (See page 30 for details.)

7. Install the HANDSET BATTERY PACK by plugging it into the BATTERY CONNECTOR

inside the BATTERY COMPARTMENT.

8. Place the BATTERY PACK inside the BATTERY COMPARTMENT.

BATTERY PACK

BATTERY

COMPARTMENT

COVER

Getting Started

TALK

manual 9742.qxd 1/11/2003 11:24 AM Page 15