User's Manual

1. (VOLUME DOWN) Button: Press repeatedly to decrease the speaker volume level of
the BASE UNIT.
2. Button: Press and hold down to record memo messages.
3. Button: Press to repeat messages.
4. (OUTGOING MESSAGE) Button: Press and hold down to record OGM messages.
5. Button: Press to set/check the day and time.
6. Button: Press and hold to set the 3-digit Remote Access Code for remote operation.
7. CHARGE TERMINALS: For charging the HANDSET BATTERY PACK. For best
performance, clean the CHARGE TERMINALS periodically with a damp cloth.
8. IN USE/CHARGE LED Indicator: (IN USE) Lights up to indicate that the HANDSET is in
TALK mode. (CHARGE) Lights up when the HANDSET is placed on the BASE UNIT for
charging.
9. ANSWER FUNCTION ON/OFF (ANS. ON/OFF) LED Indicator: Lights when the answer
function is turned ON.
10. SPEAKERPHONE LED Indicator: Lights up when the BASE UNIT speakerphone function
is activated.
11. RING SELECT Switch: To select the number of rings before the Answering System answers
a call.
3R - System answers a call after the third ring.
5R - System answers a call after the fifth ring.
TS (TOLL SAVER) - System answers after the third ring only if you have new
messages. Otherwise, the system will answer after the fifth ring.
12. RINGER ON/OFF Switch: Set switch to OFF position to disengage the ringer on the BASE
UNIT.
13. POWER-IN CONNECTION JACK
14. RESET Button: Press and hold down for 2 seconds to reset the system and clear all
recordings.
15. (VOLUME UP) Button: Press repeatedly to increase the speaker volume level of the
BASE UNIT.
16. Button: Press to erase messages.
17. Button: Press to stop playing a message.
BASE UNIT Controls BASE UNIT
memo
time
VOL -
rpt
code
VOL +
erase
stop
ogm
5860 man.qxd 11/7/2003 5:48 PM Page 8