User's Manual

Remote Operation through a Tone Telephone

You can use many Answering System features when you are away from home. To protect your

privacy, most of the features can be used only after you enter the three-digit Remote Access

Code.

Remote Access Codes

The Remote Access Codes are preset at the factory as shown below. You can use the preset

codes or choose your own.

PRIMARY MAILBOX: 999

MAILBOX 1: 555

MAILBOX 2: 666

MAILBOX 3: 777

MAILBOX 4: 888

NOTE: If the RESET button is pressed, the Remote Access Codes return to the factory preset

codes.

Changing of the Remote Access Codes

All of the digits of the Remote Access Codes are a combination of numbers 5, 6, 7, 8, 9, 0.

IMPORTANT: Digits 1, 2, 3, and 4 cannot be used when changing the Remote Access Codes

for any mailbox (including the PRIMARY MAILBOX).

1. Press a mailbox button for MAILBOX 1, 2, 3, or 4. For the PRIMARY MAILBOX, follow

steps 2 to 6.

2. Press and hold down the button until you hear the short beep.

3. Press the or to select the first digit, then press the button to accept

the setting.

4. Press the or to select the second digit, then press the button to

accept the setting.

5. Press the or to select the third digit, then press the button to

accept the setting.

6. Press the button to return to STANDBY mode.

Answering System Operation

rpt

code

rpt

code

stop

skip

5860 man.qxd 11/7/2003 5:48 PM Page 45